How to Replace Front Wheel Bearings on a 2008 Honda Civic

1:34 removing brake caliper
3:03 removing brake rotor
5:13 removing axle nut
7:19 removing outer tie rod
8:08 removing strut to steering knuckle bolts
9:20 removing lower ball joint
10:51 new parts and old bearing disassembly
16:41 proper bearing installation
23:54 re-assembly
Torque Specs:
axle nut - 134 ft-lbs (Si model is 180 ft-lbs)
lug nuts - 80 ft-lbs
lower ball joint castle nut - 58 ft-lbs
strut to steering knuckle bolts - 67 ft-lbs
outer tie rod nut - 40 ft-lbs
front brake caliper bracket bolts - 79.6 ft-lbs
front brake caliper bolts - 25 ft-lbs

[@dutran2981]

Thank you so much,) Jack .I am just studying English for a few months ago at my 64 years old but I still understand your video even without your English explanation . Thank again.

[@jackhfletcher]

You’re welcome! Thanks for watching and thanks for the comment.

[@thatbluefa5913]

Nice video, doing mine right now. Using a grinder on the bearing race and a chisel to get it off wasn't too bad at all. I wanted to replace them with OEM honda bearings without buying new hubs.

[@jackhfletcher]

That works too! If your hubs are in good shape then there’s nothing wrong with that. Thanks for watching!

[@Goodwrench1920]

Thank you, Jack! Great video! 😊

[@jackhfletcher]

Thanks for watching!

[@Goodwrench1920]

@@jackhfletcher Yes sir. Always enjoy your detailed videos. Thanks again & please keep them coming. 😉

[@retrotellephone]

12 days ago?? Just in time. Thanks for the video, I may just bite the bullet and pay someone to do it hahah

[@jackhfletcher]

Yeah! It can be a lot to do at home especially without a press and all the adaptors and such.

[@Cringy_101]

Lit

[@lloydn1195]

Tools my friends....???

[@jeffr0]

Interesting, I have a 2008 TSX, which I thought was a dressed up civic. But my front end doesn’t look anything like that.

[@jackhfletcher]

I think the TSX is closer to an Accord than a Civic.

[@willfreethemfreethem7671]

Unless you buy the whole steering knuckle and bearing assembly it's way easier!😅🤷

[@jackhfletcher]

A little overkill… but yes, it would make the job easier!

[@RubberSideDown2]

About to do mine and yep! Buying the whole assembly is a ton easier, and it's practically a plug and play compared to disassembly all that. Definitely worth the extra money. Not much more really. "Time is money"