Lets Spice Things Up! Husqvarna 268xp Tear Down-More Mods?

Step by step Top end Tear Down of a husqvarna 268xp chainsaw
How to Remove Cylinder From a Husqvarna Chainsaw
61 66 266 268 272xp
#husqvarnachainsaw #repair #portedchainsaw

[@larryw5429]

The power stopper of the 2 series is the exhaust port. Its never going to flow the amount of air as 3 series.. They still make tons of torque but don't rev like 3 series!

[@justinweaver8107]

Gonna be sweet lil ripper❤❤

[@crazyfeller5704]

👍👍 interested to see where you go with this one.

[@D0ucheCanoe-e3b]

Nice

[@tedneitzel]

Sweet!

[@Aaron_A_Lynch]

😎

[@nseric1233]

I had no idea you already built one with finger ports in it. I also think of finger ports as extra transfer ports. They're my go to porting move in a 660 clone, I leave the ports pretty much stock then grind the fingers into them and they run nice. If I built another 272 it'll get them too, the last one just had some clean up work and no gasket.

[@JandSChainsaw]

Yeah the 266xp with the dyed plastics

[@ChainsawSanctuary]

😮

[@eurokid83]

I ran a 268XP top end on one of my 266’s and wasn’t all that impressed. Transfers and intake are bigger on 268, but it’s also got a bigger combustion chamber. Even put a Hyway pop-up piston in it and still didn’t have the grunt I was expecting. Put the 266 cylinder back on it with an eliminator kit and she’s a ripper now. Should also mention I ran the same (266XP) carb and muffler on both cylinders.