Jane 16 assembly

[@shuttlepilot]

Thank you for such a clear and detailed video. This works great in conjunction with the printed instructions that accompany the loom. Have been setting mine up today, and this vid makes it so much easier than I thought it would be! 👍👍👍👍

[@shuttlepilot]

Just finished assembling my beautiful Jane, 16 shaft, 50cm. (Had to take a few days off in the middle of putting her together). She is absolutely beautiful, and I can't wait to get a warp on her. Thanks again for the excellent assembly vid!! ❤❤ Note: For others putting together their harnesses, all of my plastic side panels had very sharp burrs on their bottom ends, one even cut my finger, and also another slight burr along one edge. I had to sand them down and buff them. Was surprised as I love Louet products, always very high quality. This was perhaps poor quality control at the plastic molding step, or maybe just on that particular production run.

[@lizarthur2915]

Thank you Dave! My loom just arrived. I will be assembling it tomorrow.

[@dsmith3731]

Hi, it's now 8 months since this video was made, and I'm still seeing pictured the loom stand without knobs in the two online shops I've been considering buying the loom from. Is it not out yet, or have they not updated their photos?

[@LouetWorldwide]

Likely just not updated photos. What ships has the knobs to quick disassemble/assemble.

[@mariajump7537]

Thank you for such a detailed video. It worked great at assembling my new Jane 16 shaft, 70 cm. I do have a question though. When I level my harnesses, the 8 in the back hit the black grommets when I set them to the specified height. Has anybody else seen this? What did you do about it?

[@LouetWorldwide]

Do you mean they hit the back rollers at the bottom? Just adjust the rollers a little higher - just a few mm above the rollers.

[@michaelelliott8350]

I just did exactly what you did installing the loom on the stand - but I think it's backwards if you plan on moving the warp beam/cloth beam to the stand. Don't the open holes in the stand need to be on the same side as the ratchet/pawls of the warp/cloth beams?

[@LouetWorldwide]

Unfortunately, we can not provide support through this channel. Please send your support questions to [e-mail]. Also please explain the issue in greater detail and send pictures.

[@inekefeenstra5859]

I'm curious about the shuttle race on the Jane 70 16 shafts. I hope this will also be shown soon.

[@davidvanstralen3493]

We will show that once it’s ready next year. We are closed now for the holidays

[@kathrynericksonkline5683]

All I see are hands covering up the visual. Directions that are descriptive would help.