Why is there a hose going to the carbs With antifreeze running through my 2001 FZSio
@GeorgePosey-ns8sc Жыл бұрын
FZSIO
@LegitRaceCraft Жыл бұрын
It helps regulate air temperature into the engine and keep the fuel at a warm temperature. If the air is kept closer to a controlled temperature it's easier to mix air and fuel together more precisely. A lot of cars have coolant running through the throttle body also
@kevinkellow87365 жыл бұрын
I just need to know how to attach the choke cable at the carbs
@tjhaupt69333 жыл бұрын
So there is a hose with a bulb under all that and a t in the middle I've been trying to find out where that t hose goes to and if there's a cap on that bulb can you please help me
@LegitRaceCraft3 жыл бұрын
I don't quite understand what you're describing
@darionq8456 Жыл бұрын
Running into this problem now. Did you ever find where that T connects? When I turn the ignition on, it sprays gas out of that T
@Vincegould8 ай бұрын
Anyone have a good link to the actual oem peacock?
@king_motor43122 жыл бұрын
The oil goes into the air filter, please, what is the problem?
@LegitRaceCraft2 жыл бұрын
Your crankcase pressure is too high. You can "fix" this by following the hose small that runs from the air box down to the top of the transmission area, remove the hose and put a small filter that fits over this nipple. The hose should be about 1/2 inch thick.
@king_motor43122 жыл бұрын
@@LegitRaceCraft Does this problem cause evaporation without a lack of oil inside the engine? Or cause a problem when the temperature does not work on the sprinkler?
@LegitRaceCraft2 жыл бұрын
Carbon deposits inside the engine cause this. It happens with old engines. There isn't much you can do except buy some oil additive. Lucas makes one for motorcycles, and liqui-moly does also. Only buy one that's intended for motorcycles though. And follow the directions on the bottle.
@Vincegould8 ай бұрын
Drain your oil and check for fuel smell. Replace with appropriate amount of oil.
@SuperEssEmm5 жыл бұрын
hopefully can help need to remove tank to modify air box (streetfighter) i have 1997 cat and was wondering is it the same and will i have the cut off as i have petrol in the tank =/ also hypothetically would i need to completely dettach the tank.... its just a small hole i need to make can use hand tools
@LegitRaceCraft5 жыл бұрын
+scott sinclair most Yamahas have the shut-off. I've had 3 fzr600s, one yzf600, and the r6. They all had shut-off valves. The thundercat should be like the yzf600
@SuperEssEmm5 жыл бұрын
Update... Took off tank my cut off was in a similar position to yours however a little closer to the bottom of the tank (needed a little extra tipping) tank came off easily following your instructions managed to tweak my air box and put it all back. Now I just need to replace the light and Speedo section 😅✌
@robdixon68623 жыл бұрын
What is the trick to getting the #3 hex screws loose to get the carbs out? What tool did you use? a regular long allen wrench is to thin and doesn't have enough torque
@LegitRaceCraft3 жыл бұрын
A bit driver with a 3mm allen bit works well.
@robdixon68623 жыл бұрын
@@LegitRaceCraft can you send me a picture of that because I think it would be hard to fit - the space it really tight. Are you on Facebook. I can in box you.
@LegitRaceCraft3 жыл бұрын
Sorry for the late reply. You can pull my email from the "about" section on youtube
@Vincegould8 ай бұрын
T handle is what I use.
@therider39397 жыл бұрын
Thats the carburator bowls breather not the vacuum
@Vincegould8 ай бұрын
Thanks for the clarification
@DetaoMakesMusic4 жыл бұрын
I'm having trouble getting the airbox back on 🤦🤦🤦 anyone have suggestions to get this damn thing to slip back ontop of the throttle body?
@LegitRaceCraft4 жыл бұрын
You can put a little water on so that the rubber is slipperier. They are usually a little difficult to put back on
@selvinselvin53124 жыл бұрын
Power tune work like charm
@jsteez76563 жыл бұрын
Probably figured out but silicone spray
@andrew72028 жыл бұрын
What model year is this? I have an 98 and i need to clean my carb
@LegitRaceCraft8 жыл бұрын
+andrew montgomery there are very slight differences between the 98/99 R6 and the 00/02 R6, but I doubt there are any differences with removing the tank to get to the carbs. You should be able to follow my videos on pulling off the carbs.
@andrew72028 жыл бұрын
+Hournine Racecraft thanks man
@BruceAllentools7 жыл бұрын
not a bad tutorial but you could have cut it in half by not talking about unnecessary things. overall not bad... good job.