JDD OMNI TONE ARM INSTALLATION GUIDE

[@ryan1845]

My new JD carbon fiber tone arm on my Omni wiggles... It looks like the side holes, near the gimbal were drilled to big. The screw will not tighten and just falls through the tone arm when I try to set it. Any suggestions? The original tone arm does not have the two large holes that the JD carbon version has...

[@bendabbin651]

Ive got the same issue, looking for a solution

[@fedobeatz]

Installed the Mod today ! It works, no Problems. It haves the hole because its Made out of Carbon and Not Metall like the Factory one. Otherwise it would Break if u screw it to tight. Hope that Makes Sense. Maybe Jesse Dean can give u some advise/tips. Beat - Fedo

[@jopetevardone2770]

😍🔥🔥🔥🔥