JO PO Grips Twist | Thumb Installation Series

Рет қаралды 10,361

Күн бұрын

Пікірлер: 13

@byronfranek2706 Ай бұрын

Some of the shops in my area are apparently using Turbo bits to install JOPO. Had a ball come into the shop with JOPO outer installed 1/8" too shallow, and the slug I installed for him was cut down 1/8" short of standard depth JOPO because of this, which was only discovered later when I drilled a blank ball for him. Yikes! We really do need a some kind of a depth gauge that can be twisted into an existing JOPO outer to determine if it was drilled to standard depth.

@bigboots6114 10 ай бұрын

i absolutely love these

@crashbang7217 10 ай бұрын

How much deeper do these go. I onow switch grip is pretty deep and just wondering how much more core is coming out with these

@spectrebowling 10 ай бұрын

Its 3.22”, so it goes go deeper. If you check the installation document on the Jopo website that’s where I got the depth number from.

@2bcsparky 6 ай бұрын

What additional work is necessary to line up the insert correctly on a second ball to ensure an existing thumb insert is directionally correct on subsequent balls? Is there a "true" line on the sleeve?

@markbuffa5840 6 ай бұрын

Yes. At 4:07 you can notice that there is a line on the outer and I line that up with the center line.

@BboyLazy2 10 ай бұрын

Hey Mark! Just had this installed at your shop the other day, but I cant for the life of me get the thumb out (I didn't get the key) Is there any way to make it "looser"? Thanks

@markbuffa5840 10 ай бұрын

You’re going to need to wear out the clips a bit. Basically lock, unlock a bunch of times to loosen up the clips. If you wanna bring it back to us so we can double check.

@BboyLazy2 10 ай бұрын

@@markbuffa5840 Hey, just saw your reply! Is there any way we could set up an appointment? I also had questions about thumb hole size/shape

@spectrebowling 10 ай бұрын

Yes there is a booking page on our homepage and also you can call the shop to Book some time or simply walk in.

@Kanogaming-r6q Жыл бұрын

can you install it on a ball thats already been drilled does it hurt the the ball?

@spectrebowling Жыл бұрын

yes, it can be done. Since the outer sleeve diameter is larger than the slug, we just need to center it and the process is the same ;) hope this helps.