John Deere 329D Park Brake Code 522379.05

[@Zea_27]

I have a problem, my John Deere 310J. The engine starts normally, the steering wheel is normal, but I can't stop parking.

[@meh-canics9628]

Check your solenoid

[@Tom-pn5sk]

Where did you get those awesome gloves

[@meh-canics9628]

From the local parts stores, and shop supply stores. They come in Green as well

[@Austin__]

Hello - my John Deere 329D engaged the parking break suddenly during operation and will not start again. It continuously says “cycle lap bar” any idea how to fix this issue ? Thanks !

[@meh-canics9628]

Check the lap bar sensor, and the Wires to it

[@jasona6222]

Mine is not a John Deere but it does have same duetz connectors …my question is, do these run on straight 12 volts or 12v and then drop voltages to hold typically?

[@meh-canics9628]

Depends on the setup. Usually is just 12 volts

[@bigcheefin1hmfic679]

My 329e tracked skid stopped suddenly while pushing dirt but only the left side. I changed the left side wheel speed sensor but still a no go. As that and the right side sensors where throwing codes. Any ideas?

[@meh-canics9628]

Some of those skid steers were notorious for the drive motors going.

[@tommylutes524]

how did it work out mine just did the same thing on the left side 329d right works loader works left side is dead

[@tommylutes524]

Hi I just got him to my John Deere 329d and it’s telling me my right hand joystick is out of center I just replace this May of last year it’s worked fine ever cents but now it’s back to Tel Aviv my right hand joystick is out of center any ideas or did you make any videos on this I really hate to spend another $1500 thank you for any help

[@meh-canics9628]

Hopefully a recalibration will fix that, but it's usually a joystick issue. There might be a warranty on it?

[@JoseArias-yy2ec]

hello my John Deere has a fault that turns on but does not remove the parke

[@meh-canics9628]

What does the code say?

[@tommyrez8719]

My John Deere is doing the same thing but I checked all Thoes wires and they are good. What else can I check?

[@meh-canics9628]

The solenoid itself, if you can, swap out the solenoid with another to see if that works! Or if you have an Ohm meter, check for continuity

[@leahsiwale8567]

Hi my john dear machine is engaging gears but not moving...wat could be the problem checked solenoid ok

[@meh-canics9628]

Tires or tracks?

[@tysonthomson4659]

Hey. I have a 326D and I'm not having this code, but the wires look good. What next?

[@meh-canics9628]

What is your code?