jura brew unit servicing with detailed info not found in any other videos part 1

[@mguerramd]

Those two T20’s on the water pump side, by the encoder, that hold the brew group often have thread lock compound. Don’t use an impact driver to try to break them free. The heads are very shallow and you can EASILY strip them out. Push as hard as you can in to the screw head while turning to loosen, and support the other side of the machine. Sometimes I hit them with a bit of PB Blaster, AeroKroil, Boeshield, or other similar thread loosener. And let that sit a while, then try again. Those are machine screws that screw in to metal and can be super tight.

[@FredG-2012]

Two questions. Rebuilding my first ENA3 brew group. 1) the little pipe shaped piece that fits at bottom has a small gasket that fits on the 90 degree bend end, does that gasket just fit on END or does it need to be put on further past first ring? 2) bottom of my brew unit does not have the brown plastic shroud that fits at bottom. Our family has a ENA5 so wondering why this is? How is this brown shroud removed? Sorry system won’t allow me to send photos.

[@hugomarconi3075]

Me gustaría traducido en español y tener contacto con ustedes ,tengo máquina delonghi no puedo entrar al menú

[@mguerramd]

I have a corollary video to go with this one: kzbin.info/www/bejne/e365XoaFqZllptk