How to install roller blinds | JYSK

[@rekagy744]

How can you open the window after?

[@emilgustafsonfilmfoto]

How to remove the first part!!!?!?!?!?!??

[@AO_Rourke]

Did you ever figure this out?

[@emilgustafsonfilmfoto]

@@AO_Rourke well sort of, its just brute force, but I broke the first one that I tried to remove, which led me to this video. So be careful it´s ease to break the plastic when doing it wrong.

[@AO_Rourke]

Thank you, I ended up attacking it with brute force. Broke quite a bit of the plastic before I calmed down and pried it open more carefully 🤣

[@codorin]

i only received 1 screw with anchor in all 4 of my blinds. lol now i have to go buy some anchors amd screws. why only 1 when 4 are needed? better if there were none.

[@Detteermiig]

yeah quite silly, but it's apparently just for the rolling cable

[@petergallagher9981]

How you remove @0:16

[@rehearsalpianist]

Did you work this out as I’m non the wiser from this video. Ridiculous instructions

[@petergallagher9981]

@Rob Owen no i brute forced it prying it with a flathead screwdriver

[@fredrikthelin5542]

Jysk har aldrig någonsin svarat på varför alla 3 upplåsbara sängar gick sönder i ventilerna efter några sekunder, således ingen ersättning trotts långt över tio år av påstötningar. Sjukt beteende som alltså ännu inte har blivit löst av dem!!!

[@fredrikthelin5542]

Jysk har aldrig någonsin svarat på varför alla 3 upplåsbara sängar gick sönder i ventilerna efter några se kunder, således ingen ersättning trotts ca tio år av påstötningar. Sjukt beteende som alltså ännu inte har blivit löst av dem!!!

[@BarbaraHernandez-o4m]

Trent Points

[@lahjasoini5628]

Etsin sänkyä 120 koko

[@saikee2404]

Мразі, ви ж продаєте інакші ролєти, до тих які зараз в продажі інструкції нема і комплектація просто без слів…. один шурупчик мені дали… дякую…

[@yuliangeorgiev]

Poor design made to brake easily.

[@petey3005]

Worst instructions ever. They don’t mention how to remove the first part which is probably the most important step because if you break it, it’s only good for the bin after that. I finally managed to remove it by using my finger nails, getting them in between where the plastic meets the steel tube and pulling. It just slides out. Now I just hope I can figure out how to tension it when I get to that part.