Рет қаралды 32
Today on The Ebike I'm wiring up a 3 speed switch
I used to use a loop of wire on a 2 pin connector to select what speed(mode) I wanted.
For wire I'm using 3 equal lengths of green 14 AWG Cut from a scrap vacuum cleaners power cord.
The button is new so are the quick connectors, but they dont need to be.
I soldered the wire ends after folding them, I don't think it was necessary but it was done anyway for fun.
The wiring diagram below
/-----------green - blue----------\
Switch--------------green - black---------controller
\---------------green - brown---/