Kawasaki KZ400 Vintage KZ 400 Cafe Racer - 1/3 Engine Head Remove Cam Shaft Cylinder Flywheel Rotor

In this video we are tearing down a motor to a 75 Kawasaki KZ400 chain drive.
Also more common issues with the Kawasaki watch:
• Kawasaki KZ400 Vintage...
• Kawasaki KX80 Kx Dirt ...
• Kawasaki KX80 Kx Dirt ...
Patreon / midnebraskamotorsports
Instagram / midnebraskamotorsports
Check out our eBay store at stores.ebay.com/midnebraskamotorsports
Shop for parts at: midnebraskamotorsports.com
We Disassemble: Clutch Head Cover Cylinder Piston Stator Points Rotor Magneto Generator Alternator Coil Camshaft Cam Chain Tensioner Rocker Electrical Cases Bottom End Case Set Transmission Shift Drum Fork Gear Shaft Flywheel Starter Idler Clutches Bearings U Joint Yoke Driveshaft Shaft Float Main Jet Bowl Slide Needle Seat Intake Assembly

[@iReinTV]

was worried I would have to take off both sides of the cases to change my clutch push rod seal, you just sliding that rod out just told me itll take me 10 min to fix my oil leak contrary to the 50 other forum posts i was seeing lol.

[@stockton350]

This helped a lot when I had to change the cylinder head on my 77 KZ400. Thanks for sharing this.

[@atbigbucks4u2]

Hey I really appreciate the video of the breakdown. I did a rebuild on my 76 kz400 and I'm trying to get it going. I was wondering if you could give me tips on getting it started again. I've checked valves and timing an cleaned carbs. I have spark but I noticed today my compression is low. I replaced the rings and gaskets when I did the rebuild. Not sure why it's so low. Any advance will help

[@atbigbucks4u2]

Tyson Ratliff Deals0040 I think it might have been from me removing the top cover when I was lining up the arrows on the timing chain. I check that first. But as you stated with the valves: dont you set the right side first and then turn it again to set the left side like the book says

[@atbigbucks4u2]

Did you make a video of the rebuild or just the break down

[@mikekrutel6954]

What size bolt did you use to get the dynamo rotor off?

[@alexanderthorsen2838]

hey i have the same bike ut everting is pulled from it how to conned the starter silinoid and the starter du the starter button

[@nfinnnn]

Dude , beating the alternator cover with a hammer just like that? Seriousy?

[@lukesims6636]

Yeh I was thinking it was a bit hammer happy !! 👍🏻🏴󠁧󠁢󠁷󠁬󠁳󠁿

[@rustyhoo1000]

i cringed

[@jojonels]

was about to say "my man, chill with the hammer"