Kenda K413 Tire Review // Honda NAVI

[@BowHunterPlanet]

If this was today would you have done 12" in back? Or is the 10 working good?

[@mikey.mike.]

I probably would try out the 12 inch. Just hate that you can't go as wide

[@just.my.2cents]

You tell it like it is...genuine Guy you are! Thx for sharing.

[@mikey.mike.]

Greatly appreciated 🙏 Thank you for viewing!

[@shade_angel1445]

Can i suggest a drop center tool for mounting the tires? Its surprisingly easy to do with drop center tools.

[@mikey.mike.]

That would have made it so much easier for sure!

[@marcnissen578]

Once again great info video I love my Navi and I will get the same tires you got , peace

[@mikey.mike.]

Much appreciated!

[@escalatorcan_gaming6123]

How has the honda navi held up the whole time you’ve owned it?

[@mikey.mike.]

No complaints on quality despite the cheap price. It's held up nicely, and is stored outside covered. I have not had any issues mechanically or cosmetically to date.

[@therahh2435]

Did you have to modify the break line mount?

[@mikey.mike.]

I didn't have to, but some people end up bending the braking link or removing it. I chose not to, but it's really close to the tire. It could rub depending on weight

[@ryangraham729]

I love this tire on my navi . I actually bought a few just in case they are not available which happens with these tires . Buy a tire swap tool and do it to it !

[@mikey.mike.]

It's a sweet setup. Kinda wish the Navi came with 12 inch rears though

[@user-su9yo3hp9q]

Thanks so much for the video. I wind up getting them. How PSI are you using on the rear tire?

[@mikey.mike.]

Appreciate you viewing! I'm currently running 30psi on the rear tire.

[@IDKMYBFFDPJ]

since the front is out of stock, do you think this could be a good sub? Kenda K413 Front/Rear Motorcycle Bias Tire - 120/70R12 51J

[@mikey.mike.]

I think it may be too wide. I probably have less than half on inch of clearance from the shock boot. Any wider and it may rub.

[@libbiemoore291]

I just ordered the wider tires from Amazon, but do I need to buy new inner tubes or will the originals fit? I know next to nothing about tires, so any advice is really appreciated. My Navi has a little over 1,000 miles on it. Thank you!

[@mikey.mike.]

No tubes required. The navi uses tubeless tires, so you're all set. good luck with your navi build! Ride safe!

[@libbiemoore291]

Thank you so much!!

[@sheba6779]

Hi great videos.. would you happen to know the recommended tire pressure for the Honda Navi? Thanks

[@mikey.mike.]

Appreciate it! According to the service manual Cold tire pressure for the front should be 22psi and 33psi for the rear. However, I'm not sure if that'll relate to any tires outside of the stock tires it comes with.

[@BowHunterPlanet]

Do you need TUBES for these?

[@mikey.mike.]

No tubes needed for these. They are tubeless tires.

[@IDKMYBFFDPJ]

Hey Mikey, how was clearance with the back brake and tire. Typically I hear people need to pull it away from the tire? Was that the case? Any trick to bending if you did do it?

[@mikey.mike.]

The tire probably clears the break levers by a quarter inch or so. I haven't had any issues with it rubbing so far. However, I do check the psi often to ensure it doesn't widen due to a low psi. Be cautious and check on it before every ride if you go this route.

[@skiff207]

So the rear tire doesn't rub against the brake correct?

[@mikey.mike.]

That's correct. However, it's super close so I always take a look at it before I ride.

[@congerscott6064]

The difference is night and day , looks bad ass ! Good choice man 👍.

[@mikey.mike.]

Much appreciated! No regrets here. They've been a solid choice.

[@asmrlon7966]

The tires look great! Looks like you got the sizes right.

[@mikey.mike.]

Cool! Thanks man! Appreciate you viewing.

[@detectivedipzhit]

Bad ass man thanks for sharing I wanted to upgrade my wife’s Navi.

[@mikey.mike.]

Sweet! It's definitely a peace of mind knowing I have more grip on the turns.

[@HELLCAT7]

Howd you get it to fight. mines os too big for the tire rim

[@mikey.mike.]

A lot of swear words and determination 😅. It helps if you lay the tire out in the sun for a bit. The rubber softens up making it easier to work with. Use a lot of soap water. Or just plain dish soap to help slide it on the wheel. I watched this video to help me out. This video worked the best for me. kzbin.info/www/bejne/eJ-Yf5KNiZyYf9U

[@MiniMotoPlanet]

Why go with 10” in back instead of 12”?

[@mikey.mike.]

During covid it was impossible to find parts for it.

[@simply_leonides]

Did you gain any top speed?

[@mikey.mike.]

I never recorded my top speed with the stock tires. I'd imagine it would lose some speed due to the extra tire weight. Although I'm not completely sure without seeing any real data.

[@simply_leonides]

@mikey.mike. figured I'd ask. I know some guys are saying it does with the rear converted to a 12inch figured it might be the same if just using a bigger rear tire

[@mikey.mike.]

The 12 inch wheel covers more distance when rotating than 10in wheel. To my knowledge that's why the 12 inch has a higher top speed.

[@ziploco]

Did you have to balance the tires?

[@mikey.mike.]

No sir. Most tires do have a mark of where you should line up the valve stem though.

[@ziploco]

@@mikey.mike. thx for the info great vid

[@mikey.mike.]

@@ziploco appreciate it!

[@lordkimjungunbombmiggameri9490]

❤ doing this video

[@lordkimjungunbombmiggameri9490]

I wouldn't ne er been able to do that

[@scorpiojuan1966]

My front tire rubs on fork cover

[@mikey.mike.]

Did you install the k413, and check the psi level?

[@lordkimjungunbombmiggameri9490]

I wouldn't ne er been able to do that

[@mikey.mike.]

Definitely wasn't a walk in the park