3G Eclipse Mass Airflow Sensor and Throttle Body Cleaning.

[@helpingheals]

Wish me luck! I'm going to attempt this on my 2007 GT Spyder. Thank you so much for the video! Hopefully this easiest of items will correct my running to lean issue (171 and 174 codes).

[@Killobyte]

Hope that fixes it for you. There are a lot of things that can cause those errors. I’d check for vacuum leaks first. Here is a link that has some useful info: www.club3g.com/forum/problem-reports/222729-p0171-p0174-vacuum-leaks.html

[@augustopurizagavergara155]

Thank You very much,very helpful video,blessings!

[@B5s4]

He said “caked on gook”……. 😬😐😑🤐😶That’s racist bro, I know it’s an Asian vehicle and all but damm

[@roamingsamurai9012]

thank you very much Mr. Kill!!

[@daveleary5830]

I sprayed this when I cleaned out my '04 Diamante LS MAFS. It worked like a charm and the car is running smooth now. You CANNOT use anything but MAFS cleaner on these because this cleaner will NOT leave any residue that would interfere with the operation of the sensor. I swear by this CRC product. Other cleansers will leave residue that will interfere. I agree with Kill-O-Byte in using this spray. I also used this on my old '97 Galant without any adverse effects.

[@cocowawa1010]

These Mitsubishi karmen vortex MAF sensors are not cleanable. The hot wire you see is Intake Air temperature sensor. They don’t use hot wire to measure air flow . Guys Look it up. They will be damaged if sprayed.

[@10Fails1234567890]

cocowawa1010 It’s even stated on the can to not use on Mitsubishi mass air flow sensors

[@M00di]

I bought the same spray you are using in the video with out paying attention to the back of the bottle until I went home it says do not use on vehicles with Karen-Vortex, e.g Mitsubishi. Did it damage your MAF after you cleaned it? I'm thinking of giving it a shot. Nice video

[@Killobyte]

I’ve used the one I got multiple times without issue, but it’s a can from many years ago so they might have changed the formula. I’d go to an automotive store and try to find one that says it’s safe for your car. A store employee might be able to assist.

[@Integrity.is.everything]

What did you find out about this

[@mehdimazloum1413]

i cleaned maf sensor for pajero and then it damaged. so take care for this videos.

[@dereckc9469]

careful spraying into throttle body, lookl were the iac is. I killed mine. now I only spray into a rag. if I want to spray directly I would only after removing iac

[@DenisDamulira23]

Great info,gonna do it on my GTS this weekend...150,000 miles...getting p0300 code,replacing plugs,wires,cap+rotor but sometimes this is the cause

[@RAGBOY562]

So im a noob when jt comes to cars. I had my friend help me clean it. He decided to spray whatever is behind the throttle body. Now my car is acting wierd. Do i open it again and let it air out and clean it? Im an idiot for letting him do it for me.

[@richardburns9772]

RAGBOY562 yes you are

[@daveleary5830]

Something else was touched in the process. Make sure no vac lines were loosened or any wiring exposed/disconnected.

[@duariweiss7188]

I cannot find any MAF cleaner that can be used with Mitsubishi?!? The brand you are using in the video clearly states not to use with Mitsubishi. I have visited lots of forums with mixed reviews. People saying they used it and it was fine and others saying it caused damage (they were just cleaning as maintenance) then Had to replace MAF. Mine is throwing PO102 code. I am thinking I just need to replace. I read an article that with this type of MAF you should never clean. Wondering what others experiences have been?

[@Killobyte]

The version of CRC MAF cleaner that I have says it was safe on any car. I have used it several times on that 2001 Eclipse which now has 186k miles. I’ve not looked for a new can so don’t know if they still make a version that is safe for a Mitsubishi. If someone knows of a brand that still makes a version that is safe please let us know. If your only other choice is to buy a new one, I’d try using a small amount of cleaner first. It’s not like you have much to lose.

[@duariweiss7188]

Kill-O-Byte thanks for the reply. Yeah I couldn’t find any cleaner that said it was ok. You are right I should have tried it to see if it would help. I just replaced the damn thing. 2002 here and it just rolled 187K the day after I replaced it! Wondering how many miles I squeeze outta her?!? It has been a great little car for my daughter.

[@luuuediiazz298]

VERRRY HELPFUL thank you 👍🏼🎉🎉

[@jeffreyhickam1459]

I have a on eclipse gt 3.0 and it start's with such a low idle that if you don't tap the gas a lil she will stall, but once she's warmed up not a problem. I have replaced the idle control valve & removed my cold air intake with no luck. Do you think that this will help? Any suggestion's?

[@kipp-n-dotz4690]

Jeffrey Hickam I know this is a year old but did you ever fix this problem I’m having the same issues

[@f86tune48]

@@kipp-n-dotz4690 same ;-;

[@chriscars3224]

@@f86tune48 mine just started doing it too.

[@f86tune48]

@@chriscars3224 😂😂😂 I sold mines, just got a 2014 FRS

[@chriscars3224]

@@f86tune48 had the car a few years only paid $1500 for it.

[@tylerstetka7882]

What type of MAF cleaner is he using?

[@ericsalas9219]

appreciate you making this video!

[@jackalwatermelonred]

did all that and still did the same thang

[@GoatMonkey]

Thank you for this. Was worried I wouldn't be able to find a guide. Thanks again

[@justindominicpangilinan7485]

Tnx for the video

[@69sddo91]

I sprayed my MAF with the cry then read the label and not supposed to because it's a karma vortex but it didn't affect anything mine was the iMac mitsu montero 97 ls 3.5

[@kevintolentino3507]

Which one did you use?

[@fransicofuentes704]

I almost sprayed my Monty before I read your comment

[@sdivan3g931]

What product do you recommend for MAF and throttle body?

[@peepeepoopooicantgochoocho5670]

look at what he uses in the video he says it

[@michelelister7205]

Thanks for the tips. I had check engine codes for the mass air flow sensor in my 02 Eclipse. I got all the cleaners you mentioned and a new sensor. After cleaning the sensor the car ran a smidge better so I replaced it. Now my Eclipse runs great again. Also the tip to use a 10mm socket saved me time too. Thanks!!!!

[@fonzyr6996]

L

[@gypsygirl1485]

My 2003 Mitsubishi GT Spyder V6 has been in and out of the shop for a month now. The engine service light keeps coming on, first they replaced ALL the fuel injectors, then the computer...Yep the engine service light is still coming on. I'm getting frustrated because as a female they won't listen to me. I'm starting to think it's becoming a guessing game as to what to do next.. My car only has 97,000 miles on it and has always been maintained by the 2 owners (female). HELP!! What can I suggest they do next. Timing belt done, spark plugs/tune up done water pump done...I'm simply lost as to what to do!!

[@richardburns9772]

Gypsy G: quit complaining about being a female and just trade it in.

[@KatarSin2]

I am sure that MAF cleaner is not for Mitsubishi's.

[@FrangellGaming]

Yupp, it's there at 5:01. This chemical damages the air flow sensor. :/

[@Keiji3G]

Roger Saux I didn't notice until after i sprayed the shit out of mine...

[@havee9876]

Keiji3G Did you have to replace your Mass Airflow Sensor? I did the same shit and sprayed mine

[@moniquegainey3292]

Soo yes wat happened with y'all's cause I'm TEMPTED to spray TF outta mines I have 2001 Mitsubishi Spyder eclipse 2.4

[@helpingheals]

He stated right there in the video to read the products before using them.

[@luiscortes9650]

How can I now if my clutch is bad after cleaning mass air flow sensor and no happens anything

[@FIGHT101TV]

I just cleaned mine....it's been cutting off when I park..I hope they $10 spray cleaner works

[@Killobyte]

Good luck!

[@FIGHT101TV]

@@Killobyte it was my alternator that made the code not turn off! So now it's finally over!

[@Killobyte]

Interesting, glad you got it working again!

[@B5s4]

Your supposed to let it dry naturally also

[@joserico9604]

so i have an 03 GT with an aftermarket intake will that maf cleaner work for mine?? it's the same one as the videos

[@Killobyte]

Jose Rico MAF sensor should be the same, just might be in different location.

[@joserico9604]

Kill-O-Byte on the back of the maf sensor cleaner can it says do not use on Mitsubishis, would it still be ok or what??

[@Killobyte]

Jose Rico I wouldn't use it then. Get some that says it okay to use on Mitsubishis or all vehicles.

[@daveleary5830]

@@Killobyte I've never seen it in the stores with more than 1 to select from.

[@mfm7234]

Which CRC cleaner are you using? Is there one that does NOT say not for use with Mitsu?

[@Killobyte]

The CRC MAF cleaner I used in this video said it was for all manufactures. I don't know if they still make it or not.

[@burnhotrobinson8418]

Touching the diode with a cloth, rag or towel on the ceiling won't cause any harm. In case any one did accidentally touch it and thought that was a sensor, it's a circuit fail safe feature to prevent further damage in the event of an electric anomaly isn't it?

[@novalsatria3490]

that is thermistor (its like resisor but its change resistan by temperature), and its used to detect air temperature

[@juanguerrero4440]

Do you know if u need the MAF sensor when is turbo

[@bertcoll6968]

Thank you

[@jaha8241]

can i clean those thing using throttle body spray?

[@10Fails1234567890]

Azhar Mohamad Nor clean your throttle body using a throttle body cleaner. If your mass airflow sensor is acting up, get another one. They’re not designed to be cleaned

[@haroldwood3808]

like the vidoe....

[@luiscortes9650]

I have a 03 Eclipse gts,.it will work?

[@Killobyte]

Same general principal but location of throttle body, etc. may be a little different.

[@wrench]

my MAF sensor on my GS doesnt have the honeycomb but the rest is the same, I sprayed the shit ton out of it with the cleaner and you're not supposed to.....