Kyosho Inferno neo 3.0 Front diff Upgrade and Novarossi Tuned Pipe

[@XxXdaviidJDMXxX]

Awesome vid, way easier watching this vid. Thank you m8

[@sidneypritchett]

👏🏽 Keep up the great build bro

[@garagebuilds]

Preciate that @Sidney 💯💪🏽

[@infamousrc2536]

I have the same neo 3.0 as you do. I found out that the sway bars on my mp9 will fit on the neo. Helped out a lot with handling

[@garagebuilds]

Nicee! and Foreal . thats good to know i will check them out Thanks m8! 💯

[@infamousrc2536]

No problem! They only issue I’ve had with my neo is the fuel tank lid will leak if I run more than one tank of fuel

[@garagebuilds]

Ohh thats not good , why ? could it be the return spring went bad or a bad seal , that should not happen means something might not be right with tank .

[@leonardosena6338]

Thank you! Wich wheight you used at diffs and shocks? +1 sub

[@garagebuilds]

diff 7-5-3 great starting setup and for shocks i like to use 45 front and 40w in rear

[@Alguticent]

There were only two small gears attached to a bar, but you put two more right? Can you leave only the two that you already have? Thank you

[@garagebuilds]

Yes it is ok to run the stock 2 gears

[@Alguticent]

@@garagebuilds mmm ok dude, I'll buy two more for next time, thanks

[@garagebuilds]

That would be great !

[@v1zno547]

i have some trouble taking apart the joint cup, any suggestions?

[@garagebuilds]

need to take apart diff and there is a pin holding inside behind the gear

[@v1zno547]

@@garagebuilds thanks 🙏

[@targetoz5470]

Is the part number for the front diff upgrade the same as the rear?

[@garagebuilds]

yes you can do it to the front center and rear