Now I know how to replace disco boot floor thanks for showing
@DavesInHisGarage5 ай бұрын
Great job buddy, good to see some folks getting the work done to keep them going a good few more years 👍
@DavesInHisGarage5 ай бұрын
I will tell you what I use to clean up the primer for the spot welds, I get an 6 or 8mm drill bit and grind the end flat, fits through the hole and preps the exact area to weld 👌 stepdad passed that on to me.
@Meadowcrafting4 ай бұрын
I will try that out next time
@Phil-fj5fe4 ай бұрын
Brilliant. Good job. I've an old 300tdi that's gone in the back. I wish you lived near me . I hope mine go's aswell as your video repair went . Kind regards phil
@Meadowcrafting4 ай бұрын
Thankyou Phil, I have done a few boot floors now! Take your time cutting it out if you have a good edge that can be salvaged from the side floors around the wheel tubs. Good luck Rich
@mirkolev65523 ай бұрын
Good description of the process but I would have taken the fuel tank and filter out, even though it is a Diesel.
@corneuys21 күн бұрын
Where in the UK are you based? My 1998 disco needs more and more work that I cannot do myself.
@Meadowcrafting13 күн бұрын
Hi I'm in Oxfordshire, unfortunately I have lost my workshop due to a redevelopment going on so it might be a while until I am up and running again!