Laser Cutting Clear Acrylic On Monport 40W

[@terryh5677]

Brother I appreciate all your videos very helpful and easy to understand.

[@cubansli3099]

Thanks Roger I just got my CO2, a K40. Just need to figure out the focus. It come with an adjustable nozzle

[@captcraig777]

Very nice. I see that the bed for this K40 has not been changed. I just bought the MonPort myself and I have only run simple lines and circles in Dollar Tree plywood. It is hard to find a good honeycomb that will fill this bed, plus have the ability to raise and lower the bed. It looks like yours works just fine without changing it.

[@rogersshop]

I have most of the things I need to change the bad and make it adjustable. Just haven't had the time to get to it.

[@captcraig777]

@@rogersshop Hopefully you can show us how you did it when you are done. I have looked in numerous places for an "all in one" solution, but I have not found anything that makes me feel confident it will be level. Thanks for the response!

[@christychessher1967]

Do u still have your K40 by chance? I'm have problem with when I do a mirror alignment the test fire button on the lid doesn't work. It doesn't light up or anything. Do u happen to know how to go about this

[@rogersshop]

Yes. In fact made two videos today with it (not posted yet). The test fire button failing is not uncommon. Or, the potentiometer above it fails making the button inoperable. Has not happened to me, but I have heard of it.

[@facundocabrera3234]

hello everyone. I have a problem with my Monport 40w. When I send the job, the laser does not fire and since I turn it on, laser signal off appears. When I press the test button it barely marks the wood. Does anyone know what this is due to? I must clarify that the machine is new