Magnificent. I followed your video and succeeded for a total cost of AUD$32. Lexus said I needed parts quoted at $20,000 on a car worth about $2,000. It requires a skill that I would never achieved without this video.😀
@bkacr50063 жыл бұрын
Great video! Thank you!
@josephg.43833 жыл бұрын
Hello, excellent video by the way. Where did you source your replacement digitizer screen?
@droppedwrenchgarage54223 жыл бұрын
I bought it on ebay for about $30. The nice thing about it was the fact that it came with the adhesive strips already attached which made installation very easy. The link is below. www.ebay.com/itm/193589657451
@bkacr50063 жыл бұрын
Where did you get those blue chips to remove the screen with?
@droppedwrenchgarage54223 жыл бұрын
Those are part of my standard electronics repair parts. Effectively, they are just guitar picks. These, however, came from iFixit (www.ifixit.com/Store/Tools/iFixit-Opening-Picks-Set-of-6/IF145-123?o=2)
@flexrico75083 жыл бұрын
That was awesome!!
@J2U8511 ай бұрын
Omg I need help my screen started going on and off until it completely stop coming on a whole year now I can’t regulate my heat/air only the bottom radio buttons work no other buttons What can I do
@iisweird48522 жыл бұрын
My navigation system is bad the screen works and can access all buttons except map, destination and menu any ideas?
@droppedwrenchgarage54222 жыл бұрын
The initial symptom I experienced was that the place I touched on the screen wasn't registering correctly. In other words, I would touch one spot but it would act like I touched somewhere else. Is that what you are experiencing? If it is, you have the same problem that I did.
@iisweird48522 жыл бұрын
@@droppedwrenchgarage5422 no i can fully touch the screen i just cant acess the menu navigation and destination buttons its come up with external system not connected
@paulcooper47583 жыл бұрын
what tools did you use.and what part did you get
@droppedwrenchgarage54223 жыл бұрын
I went ahead and added the supplies to the description. You aren't the first person who asked.
@BENZAPLANET3 жыл бұрын
Hi! I have little problem with my a/c the console said it's not connected
@droppedwrenchgarage54223 жыл бұрын
That may be an issue with one of the dozen or so connections on the back of the navigation unit (I don't recall which connector goes to the A/C). The other possibility is a blown fuse.
@BENZAPLANET3 жыл бұрын
@@droppedwrenchgarage5422 thanks! I going to replace the a/c unit controller and I hope it's going to work
@footballstar113 Жыл бұрын
@@BENZAPLANET did you find a fix for it?
@BENZAPLANET Жыл бұрын
@quamarimchenry6828 yes, it's was one small black box I buy one S.H. for 80£ and another 30£ I pay the electrician to change for me.
@footballstar113 Жыл бұрын
@@BENZAPLANET the wiring harness? it has a couple port inserts
@johnpaulson996 Жыл бұрын
How many total hours did it take?
@droppedwrenchgarage5422 Жыл бұрын
Once the nav system was out of the dash, the electronics work took about an hour. Getting the unit out of the dash was the hard part because I was fearful of breaking any plastic parts or leaving tools marks on the dash. I think all told it was about 3 hours.
@petermartin9166 Жыл бұрын
I took about 6 hours as I took a lot of care.
@petermartin9166 Жыл бұрын
Having done it once, I could get it down to 3 hours. It is not the sort of job to hurry.
@J2U858 ай бұрын
Can you do mine please 🙏🏽
@rwest19662 жыл бұрын
What's up with the weird rainbow on the screen
@droppedwrenchgarage54222 жыл бұрын
It’s caused by the resistive touchscreen grid on the newly installed panel. The resistive grid is made up of horizontal and vertical wires. When you touch the screen, a contact is made to detect where you pressed. For some reason, while filming, it is visible. It wasn’t visible in-person
@marvinviis63012 жыл бұрын
if my screen is cracked do i just have to replace digitizer?
@droppedwrenchgarage54222 жыл бұрын
The digitizer is on top and is made of glass. The LCD display is underneath and separated from the digitizer by about 0.5mm of adhesive tape. Hopefully, just the digitizer is cracked and as you saw from the video is relatively easy and inexpensive to replace.
@marvinviis63012 жыл бұрын
@@droppedwrenchgarage5422 I think it’s the LCD because I can’t feel the cracks the cracks is inside
@droppedwrenchgarage54222 жыл бұрын
@@marvinviis6301 There is a layer of plastic on the top of the digitizer, so you likely won't feel cracks. If the screen doesn't display anything or shows lines or other signs of image issues, then the underlying LCD display is damaged which somewhat more expensive repair. That one requires getting a new display which is about $300 last time I looked. It is still cheaper than paying $4000-$6000 for a replacement nav unit.
@marvinviis63012 жыл бұрын
@@droppedwrenchgarage5422 everything is displaying and showing good just the touch doesn’t work it’s cracked but everything works and displays how it should just can’t press anything
@marvinviis63012 жыл бұрын
I have a picture wish I can show you
@M14SINAL0A3 жыл бұрын
Mine is black but radio works..any toughts on whats wrong?
@droppedwrenchgarage54223 жыл бұрын
Possibly the back light for the display went out. If the display still beeps when you touch it and you can see a faint image (possibly with the aid of a flashlight shining at an angle toward the display) that is what went wrong. The repair for a lost back light requires a different set of parts than what I needed for the touch screen.
@saeldaya3 жыл бұрын
I have the same problem black but radio works, i checked all the fuses and they’re all good. Thinking of getting a used Nav unit on ebay to replace mine. M14SINAL0A what did you do?
@M14SINAL0A3 жыл бұрын
@@saeldaya yeah thats what i did...my mother board overheated...couldnt do anythimg about it 😭