Light Bar Install on Ranger XP1000

[@jasonwilson4032]

Thank you, I wasn’t sure how to get in the cab, through the fire wall.

[@JosephHunstad]

Hey, thank you for your nice comment. Yes, definitely that’s the way to do it consider subscribing. Thanks. Joe.

[@davidgillen777]

Hello Joe, are there not any plug & play harnesses on the internet that would make it simple and more time efficient. For Christmas, I received a polaris 570. So I'm doing any and all research. Thanks.

[@JosephHunstad]

First of all, thank you for your comment. You will enjoy your 570 very much. Look for a harness that has a switch so you can turn it on and off and it should be pretty straightforward. The absolute easiest way to wire it up is a direct connection to the battery, but if it has a pulse bar, that would be even better. Consider subscribing. Thanks, Joe.

[@JohnCloke-fg6jz]

Thank Joe, good video. Why didn’t you connect it to the bus bar using a dedicated plug? These seem cheap and easily available. Thanks

[@JosephHunstad]

Hey, thank you for your comment. I certainly could connect that with the single connection, but there are only so many slots available. I guess I wanted to save the other slots. I think I only have one left. Consider subscribing. Thanks. Joe.

[@quaidmurray1257]

Is the wiring harness used the same wiring harness that you linked in the comments?

[@JosephHunstad]

www.amazon.com/Nilight-NI-WA-07-Warranty/dp/B073TYH2VN/ref=sr_1_6?crid=2XD5G74VHJPFQ&keywords=Nilight+-+10012W+LED+Light+Bar+Wiring+Harness+Kit&qid=1700435084&sprefix=nilight+-+10012w+led+light+bar+wiring+harness+kit%2Caps%2C115&sr=8-6

[@caronthomas6608]

Hi. Thanks for the detailed video 👍🏻what was the fuse you used?

[@JosephHunstad]

Thank you for your comment. I believe it’s a 10 white fuse consider subscribing. Thanks Joe.

[@JosephHunstad]

10 Watt

[@diggin4alivin874]

what did you do with the blk and red wire on the pulse bar quick connect piece if you directly wired to buss bar

[@JosephHunstad]

Thank you Steve for your question. The red and black wires from the switch were connected directly to the pulse bar red and black terminals. That gives full power to the lights when they're in use. The 3rd wire coming back from the switch I connected via a side connection to a switched wire from a previous pulse bar installation so it only operates when the ignition is on. This prevents a light from being turned on when the ignition is off. Consider subscribing. Take care - Joe

[@Andrew-nu8cl]

Will not fit factory 2020 Ranger Crew 1000 bumper fyi

[@JosephHunstad]

Thank you for your comment. I do not have the standard front bumper. I have the extended brush guard which for me was useful and actually quite necessary. Thanks for the update. Yes it’s not applicable to all is it thanks, Joe