Line Facing (with the same $134 mag drill)

[@1957StrokerPan]

I should have never retired. Love your videos. THANK YOU!!!

[@EitriBrokkr]

My generation will never have that problem.

[@tyrel7185]

You’ll need to buy a bottle of blue smoke to top off your mag drill. When it runs out of blue smoke it won’t work any more. You need to keep as much blue smoke in the mag drill as possible.

[@silverdrillpickle7596]

This is a true statement.

[@zebschreiber7357]

That's what I was going to say, the magic smoke that makes it work is escaping.

[@ronsreadyornotshop]

the hole in the end of the adjustable wrench would have been easier to tighten the allen screw.

[@HOWEES]

The hole was too big for the Allen wrench size, I have done that too, but that would not work this time.

[@mortenfyhnpetersen6130]

Hello Howee, i found out that you can use your lathe as a lineboring machine, you just have to add another gearmotor on your cross slide. Also you have to make to adjustable bearings on your that you Can fit your part between. It is importen that you use a duble yoke from your ekstra gearmotor and the lineboring shaft. Greetings from Denmark

[@RichardBolger-c5b]

That big yellow thing you keep walking around has lotsa anvil surfaces 😆

[@zebschreiber7357]

The last one i did i used a square and a 6" grinder. Wasn't as pretty as a machined surface but it worked.

[@daleolson3506]

Man that thing is going fast

[@HOWEES]

I have a variable speed version, I will change to in the next video.

[@1957StrokerPan]

Like my best friend in the world (the owner of the shop) would tell me "I'd say speed that up about double!"😂

[@1957StrokerPan]

Awesome crash!!!

[@1957StrokerPan]

Face knurling! Cool!

[@chuckbeckley7894]

My heavens turn that drill speed down Wow!!!! That bit won't last long. 😱😱

[@eweunkettles8207]

hook it up to a tractor pto

[@PeckhamHall]

Spline facing 😂

[@eweunkettles8207]

needs water cooling that drill