Lippert Slide-Out Stops Not Set Fix

This video shows how to set your in and out stops on a Lippert Slide out. Good luck on your project and feel free to share, like, subscribe and comment! Thanks for watching and see more of Pebbles on Instagram at / shiba_inu_pebbles #diy #trailer #howto #tipsandtricks #rv #rvlife

[@gaziger007]

Mike, thanks for the video. The information was concise and just what I needed.

[@arhahmada]

Hi Mike, Thanks for sharing this video. I have the same exact system as yours. It's also blinking the same way exactly how yours was. But the only difference is that weather extending or retracting it stops after a few seconds each time and have to repress to repress. I tried your method but nothing works. Any suggestions! Thanks AR

[@mikesdoityourself]

Lippert Components has an email address of [e-mail] or a phone number of 432-Lippert (547-7378). These guys should be able to help. I had to try the method I showed in the video a few times before it actually worked. With the slide not going in or out all at once, it probably won't reset your stops. I would find out what's making it stop and start ( loose wiring, mechanical jam, bad switch) Good luck with your fix.- Mike

[@ryanyoung7433]

Im have this system for a bed lift of my Riverstone, Im getting that same code, but everytime I go to raise it, the motor on one side seems to active, and when I go to lower it, the opposite side seems to only work, causing it to know be crooked and put me in a pickle.....any thoughts? Would greatly appreciate it being this system on a bed isn't that common and troubleshooting knowledge is limited.

[@mikesdoityourself]

I've never had a bed leveling system, only 2 hydraulic pistons with one on each side of the bed. I would say the jamming motor may need to be replaced, or look at the tracks on both sides and make sure there are no broken teeth, or check for a possible detached, misaligned or bent track. Good luck with your project!- Mike

[@ryanyoung7433]

@@mikesdoityourself I definitely appreciate the insight. After further troubleshooting it seems like the controller is bad. Was able to hotwire it using a power probe so the issues seems to lie with the controller. $500 bucks for a new one lol

[@meganstacy7999]

We have this system and our slide is out. One end tries to come in, the other end doesn’t (it’s a big slide). We can’t bring it in to do this but this is the error we’re getting. Help?

[@mikesdoityourself]

I had to keep holding the button to the in and out stops to register the end stops. You may have a mechanical issue if the end stops aren't registering. Good luck with your project!- Mike

[@liquorlushlips151]

What if one motor refuses to move in?

[@mikesdoityourself]

I don't have a video for it, but it could be an issue with the motor itself. I recently had an issue with water getting in between the slide and the wall of the RV, hitting the top of the motor. The motor had seized and had to be replaced. With some RV's, you can try to move the slide by hand and see if you can get the slide moving. With some RV's, there is a way, underneath the slide, to disconnect the motor to get the slide pushed in or out. Good luck with your project!- Mike

[@jasonlevick2627]

what if the slide doesnt move?

[@mikesdoityourself]

If the slide doesn't move, you have an electrical or mechanical problem. Dead batteries, no power hooked up, circuit breaker tripped, mechanical jam, etc.- Mike

[@bradass]

What about just goes out on both sides but not in at all