RESTORING bose acoustimass series 3 (converting to passive “subwoofer”)

[@ksb916]

This is an 8th order bandpass. It is using two 5.25 woofers. Not bad for $15. An monolith 10 or SVS would be much nicer, but a lot more money. Good video!

[@MarcoGiugiaro83]

SI, è un ottimo progetto degli anni '80 / '90. Visto che ne capisci di Acoustimass mi sapresti dire che quel modulo bassi lavora con un Crossover? Oppure l'ottava banda fa già da filtro passa basso naturale senza filtro elettronico?

[@Bass4LifeBro]

Nice work! I converted a Bose Acoustimass 30 series into a passive system with a Bose Acoustimass 5 backplate once and it turned out great!

[@BanosSoundGuy]

I have 2 bose passive subwoofers, Looks identical but black. Sounds good!!

[@TheAschwin83]

Love them to. I even got 1 set in my car with the single cubes. Puts nice bass on a pioneer 4x 50watt mosfet. Easy to install. Ordered a bose emblem at aliexpress for on my car. Because now its a bose edition 😂😂

[@Bass4LifeBro]

@@TheAschwin83 nice! Just put a AM5 iii system in my Mazda!

[@makelovetothesound]

I got rid of that buzzing on mine with a shoe lace. just tie a bolland with the loop just big enough to fit over the top of the module. The lace should cross the vent gripping the riggess. Then slide it down the back towards the bottom. May Allah keep you in his grace and mercy.

[@MyCuriousMind]

I’ve got one of these and there is no yellowing and it works perfectly but the foam that’s behind the port has came loose and the wind created by the drivers is causing the foam to move about and it’s making this annoying flapping sound at higher volumes. Was hoping that I could replace the foam without having to rip the front plate off but it looks like I’m going to have to. Rip (before somebody says it might be foam rot on the drivers, I’ve already checked and it’s not thankfully) Very helpful video though 👍🏻

[@andrewkuhne2586]

It's not a subwoofer. It doesn't deliver subsonic sound. It's a bass unit with very average 5.25" bass drivers. Bose use proprietary circuits in their acoustimass units to protect these drivers from over amplification especially their passive units. Given you have bypassed this circuitry be very weary of not blowing them up if you are using a decent amplifier. 🙂

[@izaakgray1718]

You can upgrade it further by disconnecting the speaker terminals from the amplifier. Big improvement.

[@waterlife.1905]

BOSE is the best. No lie.

[@2081calin]

@waterlife , I bet you haven’t heard anything else right? Because Bose is it over price junk

[@Bass4LifeBro]

I noticed on the back of your front panel the old glue line that was holding the foam onto the front panel, did you ever glue it back on? That could cause odd noises for sure.

[@BaltimoreAndOhioRR]

I came to the comments to look for this! How could that not be seen?!!

[@randomtux1234]

thanks. Is there any way to use the built in power amp without a phd in engineering

[@Granny_Smith]

Is the Acoustamass series 5 passive? Mine works fine when hooked up to my setup.

[@enyckma]

i have an acoustimas 25 series II and i'm using it as an active subwoofer. u can use its amplifier as well...

[@cabraloca932]

i have one either , may you help me to use the amplifier please !

[@kekxstar1053]

Tip ... buy any modern active subwoofer that may have woofer damage , Then transfer the circuit and power units into this old bose unit and then use the rca subwoofer input as normal. A good unit to find is a sony SA-W10 and remove the top half.

[@kensmechanicalaffair]

They sell small sub amps on Amazon.

[@leemaxwell3780]

Thanks Much! This video was a life saver

[@livefree6878]

👍👍

[@Kerto8321]

This is some variation of the 6th order band pass enclosure which is not even in the audio books.. Impressive Bose design. Those concealed from the listeners drivers sound at their best!!!

[@josmith213]

8th order I *think*, gotta give Bose credit they were awesome at getting the most out of $10 woofers with their wizardry sub box magic, sucks they charged $800 for $10 woofers tho

[@Kerto8321]

@@josmith213 Imagine this bose physics combined with a high end 18 or 21 inch driver flat down to 15 Hz: the ultimate base experience. One would need though an additional band pass from 40 Hz onward which is non issue.

[@heroicmiquio6327]

Hello, Can you please tell me how I can delete the music of Bose Lifestyle 48 (Umusik)? I had once had keyboard shortcuts on the BOSE AV48 to do this. But I forgot, maybe you know? There is also a keyboard shortcut to organize the BOSE-Umusic after songs have been deleted, you also know the combination of buttons on the BOSE AV48 Media Center Greetings and stay HEALTHY

[@mano5922]

Merci beaucoup

[@taj9997]

Which glue can i use to stick the front panel again

[@Ivhez1]

How do you control the intensity of the subwoofer, originally they have a treble and bass control but now that you remove how do you control it.

[@kensmechanicalaffair]

It's full range now, lol.

[@my66k]

Very helpful. Thank you!

[@arumugamramalingam5317]

Is the 2 speakers inside the subwoofer is connected in parallel or series?

[@ruben26432]

Parallel

[@francom6230]

Btw,, they used hot glue sticks.. it was popular back then. I like Goop cuz it has perfect compliance for sound

[@georgegeorge899]

Which acoustimass is it ?

[@francom6230]

Thanks for vid,, Funny, my foam is powder too.. My powerhead is blank but it works, so I'm just gonna wire a bluetooth speaker to the aux input.. i was outputing thru the TV but Utube sounds might be off a little..

[@michaelgrayson7762]

"Wire a Bluetooth speaker to the auxiliary input?"

[@gjgrgaming6442]

thanks my friend!

[@Kornsk]

Better would be, get one more of these. Another one.

[@madblunted]

Subs are shot

[@JosePereira-cc1ju]

warning do not buy this sub .. pure junk sound .. my money went in the trash with this buy. ouch.