In this video u showed that for a particular load the reading coming same, but calibration factor according to certain displacement how to find?
@ATOcom3 жыл бұрын
Have you purchased a controller from us? If so, you can contact our after-sales team to obtain code information. www.ato.com/contactus
@danieltoronto82505 жыл бұрын
How do I hook this up to a laptop? Thanks!
@gasparigi3 жыл бұрын
Can I use this load cell with Arduino and hx711 module? (but I can found only tutorial with 4 wires). Thx
@ATOcom3 жыл бұрын
Yes, it must use 4 wires.
@alisf13133 жыл бұрын
Thanks for this great video. You demonstrated that green and white must go to SIG +/-. But I don't have these two ports on my DAQ terminal. What I have are: EXC +/-, GND, IN +/-, 350, 120, SEN +. Could I ask how can I connect those wires?
@சபரிபிரபாகர்தமிழ்35354 жыл бұрын
Y that two threaded holes in side?
@andriusgrigas87505 жыл бұрын
Could i connect 4 load cells to measure one value into this controller? And can i use it for controlling relay or something like that? For example, when weight reaches a certain level - relay should be normally closed
@Fine_i_set_the_handle3 жыл бұрын
you need a special junction box to connect the 4 load cells together and then to the controller
@vikaspatange10005 жыл бұрын
I have load cell 1000kg but don’t know how to display because i am mechanical student.plz can you tell me about display controller
I want to this gauge,display. Where this can available please...
@ATOcom5 жыл бұрын
We have upgraded this display controller, www.ato.com/5-digit-display-controller-for-pressure-sensor Our load cell link, www.ato.com/load-cell
@donaldnoel95835 жыл бұрын
Hello. How do you connect load cell lndicator with power supply?
@ATOcom5 жыл бұрын
this link, kzbin.info/www/bejne/fHK0Ypx8iJaEqrs
@mahmoudgamal26504 жыл бұрын
Help me for data sheet this controller
@muhammedirshadrm5538 Жыл бұрын
My load cell has 6 wire Rosso + Excitation Blu - Excitation Giallo + Signal Verde - Signal Bianco + Reference Nero - Reference What to do ref+ and Ref- ?
@ATOcom Жыл бұрын
If your display only supports access to 4 wires, then the 6-wire system can be changed to 4 wires: the feedback positive and the excitation positive are connected together, and the feedback negative and the excitation negative are connected together.
@108eddyegg64 жыл бұрын
do you need code for load cell
@opoanane23674 жыл бұрын
Help me ..for. 20 gr --1 kg Type loadsell?
@ATOcom4 жыл бұрын
Our smallest load cell has a weighing range of 0~3kg. www.ato.com/subminiature-load-cell-3kg-to-100kg