Longer Nano Pro 12W: Full Assembly, Setup & Extensive Testing

[@CasualDIY]

Black Friday Sale starts 5th of November! Shopping for Longer Nano Pro 12W: bit.ly/3Xk8SDh UK - www.longer3d.com/products/longer-nano-6w-12w-laser-engraving-machine?ref=mlsgvwve&CasualDIY&variant=44865082392820 USA - www.longer3d.com/products/longer-nano-6w-12w-laser-engraving-machine?ref=mlsgvwve&CasualDIY&

[@Bob.Jenkins]

Looks perfect for my, admittedly, limited needs... thanks for the in-depth review and testing.

[@CasualDIY]

Thank you for watching 👍

[@MCsCreations]

What an awesome little machine, Tomasz! 😃 Thanks a bunch for the review!!! Stay safe there with your family! 🖖😊

[@CasualDIY]

@@MCsCreations thank you kindly for watching

[@steveprice1620]

Hope you're keeping well my friend. Handy piece of kit. Good job I dont have one after seeing your great video. Because if things didnt move they would end up being engraved hee hee 😂 Take care 👍👍

[@CasualDIY]

@@steveprice1620 🤣👍 all good mate

[@bigfootjesus123]

Great video

[@CasualDIY]

Glad you enjoyed it, thank you for watching

[@johnallen8680]

Good video ! Hope you or family are not affected by flooding in the South of the county.

[@CasualDIY]

Thank you. So far we are OK. I don't think the flood wave will get to where we live.

[@tinacouch9870]

are there "general" settings for different kinds of materials to go by?

[@tinacouch9870]

Just got ours and trying to figure it out

[@CasualDIY]

I believe that in the manual you can find on the SD card that comes with the machine, you will have a list of general settings for different types of materials.

[@mikec8101]

Have you run into any issues with framing in lightburn? It’s been inconsistent for me. Even after toggling config, sometimes it just doesn’t want to show.

[@CasualDIY]

There are no issues so far, just setup the power output for framing and make sure the framing option is enabled in lightburn, and it should work just fine.

[@jessicapretz]

In regards to framing, I have the pro as well and I cannot get it to show me that little blue to frame. Any suggestions? I verified that one laser on one firing was enabled but still no luck with it framing out the work.

[@CasualDIY]

What power percentage have you setup for framing?

[@jessicapretz]

It was 2 % , longer had messaged me and asked the same thing so I upped it and was able to see it, without the red guard.

[@CasualDIY]

Sometimes its hard to see depending on the lightening so increasing the power as you did will help.