LR308 Part 05 Assembling Uppers

In this video, I continue with my LR308 (AR10) Budget Precision Rifle Build by completing the .308 Winchester upper receiver. Unfortunately I was not able to complete the 6.5mm Creedmoor in this video.
In this video I install the forward assist, ejection port cover, barrel and barrel nut, the gas tube and gas block, the hand guard, and the muzzle brake. I did run into one issue during the build. I installed the gas tube upside down, despite me stating to confirm the orientation of the gas tube. I corrected this issue off camera.
Now, I have the lower and one of two upper receivers completed. Because I am waiting for a part for the 6.5 Creedmoor, I am considering finishing the .308 upper by adding a scope. Let me know if I should wait and finish the 6.5 creedmoor before throwing on a scope on the .308.
Thank you for watching. Please like, share, and subscribe. Let me know what you think by leaving a comment, below.

[@zachvoigt4984]

Definitely learning a lot from your videos. Thanks for putting this out there!

[@jaydavis6594]

Thanks, but we really haven't learned anything until I get it on the range and compare it with the factory original setup.

[@vitosalvaggio1805]

Love the build brother! 🔥 Great video

[@jaydavis6594]

Thanks. I'm looking forward to the next set of videos.