MA3 Node setup

[@ADRENALISM]

Is it supposed to take hours for the node to update once i put the usb in? No onscreen instructions are popping up

[@CalebHoernschemeyer]

No, I’m not sure why that would happen. It sounds somewhat like the drive was not formatted correctly. Apologies I missed this, I don’t have the node so it’s hard to answer these questions. Did you ever get this solved?

[@waltersolanocamac1384]

gracias amigo por tu tiempo 🫂

[@CalebHoernschemeyer]

Thank you for the support! Planning to get into more video very soon!

[@marcmayer4178]

Hey Caleb love your content also just got my onPC 2port node 2k and learning MA3 on my own or better to say with the help of the ma university elearning and KZbin also took me some time to get my node to join the session of the onPC small tipp you can also just hover over the middle of the encoder wheel and youse your mouse scroll wheel to change values Greetings from Vienna in Austria over in Europe

[@CalebHoernschemeyer]

Thanks for the tip Marc! You just saved me a good amount of wrist pain!

[@raffaelecontegno2478]

please can you make a video like this for MA2 consol?

[@CalebHoernschemeyer]

Yes!

[@Felix_oderso]

Thank you for the video :) I'm not into gMA3 yet, but i'll try...

[@CalebHoernschemeyer]

Thanks! It has its learning curve for sure. I’m getting it down slowly, I’ll keep uploading videos as I go!

[@bobbygosal8881]

Hai bro thanks for your video 👍

[@CalebHoernschemeyer]

Thanks man!!

[@Multichillin07]

it won't let me change the IP when I click into the menu w/ the encoder, I have a grandMA3 onPC 4Port Node 4k

[@Powersfilms]

I am having the same difficulty.

[@Multichillin07]

@@Powersfilms I called them and they helped me out instantly, you put the node in ma2 mode and open ma2 on pc and change the IP within the software.

[@tonepoet1228]

spinning your mouse isn't the way to turn a light on sir. You can simply hover above and roll your cursor dial. thanks for the vid!!!

[@martijnvandekerkhof9168]

thanks very helpful

[@emmettfrancis]

u rock ty!

[@CalebHoernschemeyer]

Thanks mate! Hope all is well!