MakerX G300 2 Fit and Finish and Connectors

[@EVGizmo]

Nice controller. I hope they take your advice and use some fully waterproof connectors.

[@de-bodgery]

I talked to them directly and they responded back. It seems that is coming.

[@joaolopes8153]

The 2, small screws can secure 24pin connector, just put them and tie , rubber will keep 100% contact with case, waterproofing it almost for sure

[@de-bodgery]

Ever pay attention to how long rubber bands last? Ever try this to see if it's true or not? I'm going to posit that you need some seriously powerful rubber bands to put enough pressure on the connector to pull it down tight. I'll hazard a guess that no rubber band that will fit around the screws will work.

[@coltont4242]

So close... very surprised the connector screws were overlooked

[@DistantSuns]

I like the all aluminum case, it’s a good way to get rid of heat.

[@de-bodgery]

It will still need a heat sink, but it does make for a good heat spreader.