Making drive wheel for belt grinder -DIY/Homemade

Hello and Welcome!
In this video i shared with you my first time making drive wheel...

[@stantilton2191]

You can't ask for any better than that. Looks great and balance is perfect!

[@Fossilphill]

Great job. Thanks for the upload 🙂

[@mojamalaradionica5091]

👍👍

[@Mike61259]

14:30 Slika govori vise od hiljadu rijeci. Oba komada su perfekt uradjena. Cestitam.

[@manickamkasiasari2211]

Good job

[@mojamalaradionica5091]

Thank you

[@sonnyudenze3759]

That is an excelllent job keep it up Bravo

[@mojamalaradionica5091]

Thank you

[@kaieteurcanada]

Nice Job...!!

[@mojamalaradionica5091]

Thanks

[@goranmarinic2923]

Svaka čast majstore!

[@user-sb9bl8yf5g]

👍👍👍

[@younasdar4183]

Job very well done SIR GEE

[@valterforlano9734]

congratulations great job. for the rollers with bearings do you have any videos to see? thank you

[@mojamalaradionica5091]

Thank you. You can watch this one kzbin.info/www/bejne/f3qwpmOrpsRnbck

[@mojamalaradionica5091]

Or this one from 11:15min kzbin.info/www/bejne/i5DXm3ptea6CkJo

[@valterforlano9734]

good job sorry could you write me the external diameter and the length of the rollers thank you Greetings valter

[@mojamalaradionica5091]

@@valterforlano9734 fi50mm x 55mm

[@kaieteurcanada]

9:13 this does not seem correct with tool moving right looking from operator side of lathe... whats the story here?

[@mojamalaradionica5091]

My phone recoreded mirror video, i don't know why...

[@georgepattinson1036]

No one has a lathe at home and most don’t have welders.

[@mojamalaradionica5091]

I had nothing, now i have a lot... Goals, hard work...

[@alke5879]

NIsi ,,bobirao,, remen ili trak če izpasti,inače je dobro.lp

[@mojamalaradionica5091]

Ne bobiram pogonski nikad. To radim na valjku za centriranje...Pretezno se desava lelujanje trake ako ima vise bobiranih valjaka...

[@alke5879]

@@mojamalaradionica5091 Pozdravljeni! Zanimivo, za sebe sam napravio tračno brusilico,na kojoj sam bobiral pogonsko jermenico i jermenico za centriranje. Sad radim još dve za svoje drugove, nedaju mi mira,pa kako sam penzionist imam vremena. Sad ču da napravim na tvoj način. Hvala,pa da vidim! Odakle si? Ja sam tu blizu Ormoža. Lijep pozdrav!

[@mojamalaradionica5091]

@@alke5879 Nije greska bobirati pogonski i za centriranje, problem moze da se desi ako nisu bas lepo centrirani onda se 'bore' oko centriranja pa traka seta, sa jednim ipak je lakse iscentrirati traku bar po mom misljenju. Naravno traka mora biti dobra da nije ukrivo zalepljena jer ona necete znati jel grinder los ili traka...

[@wally10ize]

Welding with an aerosol can in close proximity is a good way to kill yourself. The propellant is often propane.

[@mojamalaradionica5091]

True, i don't do that now...