Swapped the pump with a brand new one and the tractor didnt start even though I used starting fluid on the air intake the tractor didnt even try to start. I also discovered when I took off the plate on the back of the chamber with the 4 bolts that there was an exesive amount of rust both on the plate and on the mounting part of the pump with the three screws.
@Raffuentes030999 Жыл бұрын
Hi great video, thank you. I have a MF255 and I replaced the CAV injection pump but there is not a lot of pressure on the injector lines and the pump is leaking diesel from the mounting point in to the oil. Any idea or suggestions are appreciated....
@ProductiveLiving20 Жыл бұрын
Bad seal on the pump?
@Raffuentes030999 Жыл бұрын
@@ProductiveLiving20 I guess but is there a seal in the spinni part of the pump that mounts in the spininh
@Raffuentes030999 Жыл бұрын
@@ProductiveLiving20 that mounts in to the tractor’s engine spinning hub?
@ProductiveLiving20 Жыл бұрын
That’s a tough one. Maybe low compression on cylinders and diesel is getting by rings on piston? I’m not sure but that seems like one of the only ways I could see diesel getting into the oil. Good luck on your project!!!
@Raffuentes030999 Жыл бұрын
@@ProductiveLiving20 that makes sense since the tractor was sitting and not starting for a long period of time, I am about to swap to a brand new pump again for one last time. I also noticed you used starting fluid to start the tractor. What kind? Thank you
@Raffuentes030999 Жыл бұрын
In what position should the accelerator lever needs to be to start the tractor? all the way up or down? Thanks a lot for your help.
@ProductiveLiving20 Жыл бұрын
I start mine idled all the way down
@Raffuentes030999 Жыл бұрын
@@ProductiveLiving20 Wow, that may have to do with that, I was trying all the way up
@ProductiveLiving20 Жыл бұрын
All the way up on mine is full throttle. It would not start in that position for me either.
@Raffuentes030999 Жыл бұрын
@@ProductiveLiving20 I need to try that again in three weeks when I go where there where tractor is. Thx
@Raffuentes0309995 ай бұрын
Hey how is it going, just checking in again. With two concerns this time, I hope you can help me. The first one is how much transmission fluid to add? The hydraulics weren’t moving so I added a quart if fluid and started moving buy I wonder if I need to add more. And the second is how much air do the front and rear tires take? Thank you
@ProductiveLiving205 ай бұрын
There’s a dipstick for the transmission on the passenger’s side of the tractor by the seat in the floor to measure the fluid level. On Tire pressure I would just sit it up until it’s not buckled probably 15-20 psi.
@robertstuart13659 ай бұрын
Was there anything you needed to do special for timing the new pump? I need to replace mine as well - I keep hearing that timing can be a bear.
@ProductiveLiving209 ай бұрын
I’m not sure I may have just gotten lucky. 😂. I installed it and primed it and it worked.
@Raffuentes030999 Жыл бұрын
Hi, I was just thinking what are the chances that my tractor start if there is a coolant leak into the oil? I am suspecting the water pump may be leaking, I hope and nothing worse than that.
@ProductiveLiving20 Жыл бұрын
I would check the oil level and if it’s over full or you can see coolant on dipstick or if oil is milky then there is definitely a bigger issue