Master The Slider Knot Like a Pro

[@WolfKinder3]

Nice video. I did macrame plant hangers for years and have recently been playing with doing bracelets. I wanted to see how an experienced jewelry maker was finishing this off. The knot you made is called a square knot. When you repeat the same direction instead of switching it's called a half square. It's used to create a spiral instead of a flat squared off section. You could use the half square to make a long section of a bracelet 😊

[@ritaprovencher6048]

I've been wanting to learn this knot! Thank you so much!❤❤

[@FireMountainGems]

You're welcome! Thanks for watching!

[@mhill3350]

GREAT VIDEO!🤗

[@FireMountainGems]

Thanks for watching! 😊

[@supernova4375]

great video ! we don't see anything from the start of the knot because Madame puts her fingers right in front! THANKS !

[@carolhammond9624]

Thanks for doing this video. I wish you had shown how you finished the ends.

[@FireMountainGems]

Thanks for watching! The ends are finished with a single bead. The same beads as were used in the rest of the bracelet. Then there is a knot tied on each side of the bead to keep it in place.

[@JewelrybyJeanette]

The bracelets are lovely. It would have been much easier to see if everything had been cliipped or taped down to a board. Also, the cord to make the knot should be (and was) longer than 6 inches. I find that at least 10 inches are needed so that you have something to hold on to. Thank you for showing all the variations and designs.

[@FireMountainGems]

Thank you for watching! And we appreciate the feedback! We will pass that on to the rest of the team for future videos.