I would never work on any mechanical project with a ring on my finger.
@antoniogiomo91234 жыл бұрын
Eu conheço um menininho...que esperava no portão da empresa... aguardando o Honda passar...e o café com leite (porque esse menininho era esperto...esperava queimar os fuzis dos transformadores em torno da empresa em Valinhos....ele era preciso!) Trocar os fuzis dos transformadores em "torno" (jogo fe palavras) da empresa e apostar no Palmeiras e Santos....
@vicpetrishak10772 жыл бұрын
Why manufacture a rigid type clutch plate
@ivandavalillo82098 ай бұрын
Muy bien
@gatotliuliuriyanto24314 жыл бұрын
Yes like for mekenis
@issacjosekuttivila4 жыл бұрын
why strap drive system getting damage
@mbokokapembwa90984 жыл бұрын
How much is the cluch
@polopadilla86794 жыл бұрын
Mekedo vien ya loistale gracias
@jesustrevizo31485 жыл бұрын
Freightliner m2 with mechanical clutch linkage rod having excessive freeplay on pedal after new clutch install..... .
@killerstang37905 жыл бұрын
jesus trevizo hi what was your issue ?
@killerstang37905 жыл бұрын
jesus trevizo were the disks installed backwards?
@jesustrevizo31485 жыл бұрын
@@killerstang3790 No. I removed it to double check. It was a reman clutch, thought maybe was a defect. Installed a brand new one, same issue. The pedal assembly was previously replaced. I thought maybe there's some adjustments on the crossbar mounting at firewall.
@jesustrevizo31486 жыл бұрын
On a 10 speed what causes the transmission to pop out of 4th and 9th gears?
@dhaniapinadtaya85956 жыл бұрын
Only clutch disk hold the flywheel?
@dieseltechnician62275 жыл бұрын
detent balls
@sordidsanctitythrash3 жыл бұрын
syncros worn
@vicpetrishak10772 жыл бұрын
Sliding clutches worn inside transmission
@hamakumbamalvin74015 жыл бұрын
after install new clutch , two gears enter into gear at the sam tym. what can be the problem?
@jotegg12763 жыл бұрын
shifter tower is not installed correctly the stick is in wrong hole in forks
@morgandelaware72696 ай бұрын
The shifter needs realigning
@stevenkerry31015 жыл бұрын
ceramic will fuck up your flywheel more cost
@robertschemonia5617 Жыл бұрын
@@BigBirdErnTHC run a ceramic clutch. It's not like the flywheel is going to wear out before the clutch will. And, if you can find a machine shop to do it, you can always have the flywheel turned and ground to resurface it. Organic clutches do not stand up to heat or any kind of abuse in a heavy duty truck at all. They will overheat and crack, or glaze up really bad and sometimes cause horrible clutch shudder upon release when loaded.
@mist3rasylum397 Жыл бұрын
Easy clutches are garbage, the pedal is absolutely way to loose.