MATCO Tools Electronic Torque Wrench with Angle and Flexible Head

We have the MATCO Tools ETWB100 and ETWC250 3/8" and 1/2" Electronic Torque Wrench with Angle. Not only can you torque to 100 and 250 ft-lbs, but you can also add degree of angle. TTY or Torque To Yield fasteners are the norm when it comes to internal engine parts. Whether you're torquing a cylinder head, main cap, or rod bearing; manufacturer specs probably recommend a certain torque (ft-lbs or Nm), followed up with a certain degree of angle. Having this at your fingertips on the same torque wrench is a huge benefit. #review #torquewrench #tools
MATCO ETWB100 Torque Wrench: tinyurl.com/mr2xdkb8
MATCO ETWC250 Torque Wrench: tinyurl.com/j8ry49hp
Rechargeable AA Batteries: amzn.to/3sSeHMG
Keep current with our great content:
KZbin: / shoptoolreviews
Instagram: / shoptoolreviews
TikTok: / shoptoolreviews
Facebook: / shoptoolreviews
Twitter: / shoptoolreviews

[@kobewilson640]

I just bought a full set of matco angling torque wrenches (1/4 - 1/2) with my student discount. I got all 3 for $800!! If I had to pay full price I might have looked somewhere else!!

[@randysmith9636]

I have the Snap On 1/2" and 3/8" digital torque wrench but they do not have the flex head. The 3/8 was "almost new" but did not have the calibration card with it. He split the cost with me to send it off for calibration. Edit to add. Yes, way to go Matco 15-250 ft lbs is rare. I didn't know of any 1/2 drive with a 250 max that would go down to 15 ft lbs. Thanks for the review and video brother.

[@andrewhendricks4629]

Great tool for engine repair my buddy has the 1/2 I used it and it's a great torque wrench

[@boosted2.4_sky]

I'll stick with my Gearwrench electronic 120xp with angle torque wrench.. these are nice..but that Gearwrench is great for ~$200

[@davinlaroche3029]

Foot-pounds... degrees. You say tomato, I say watermelon.

[@darwindropmazda]

Are you planning doing a review on the icon digital torque wrench? That’s the best bang for your buck and it’s made by the exact same manufacturer that MATCO and Cornwell uses!

[@MrSupernova111]

Nice! I can't justify the price for these since I only use my tools for personal use; I have CDI torque wrenches. But I can see how a pro might want something like this. Thanks for the review!

[@rodneyjenkins5538]

Not sure what you need angle for

[@AnthonyAE86IRL]

Torque to yield bolts, axle bearings, a lot of engine components both internally and externally require angle after reaching torque spec