Mazda B3000 Ford Ranger 3.0L V6 water pump replacement

[@RichardPortis]

Arthur's Projects thank you! I have been struggling to get the fan clutch off of my Mazda b3000 1999. Been at it for weeks. Bought 2 different tool sets. Finally saw your video puchased prybar and hammer. It's off and pump replacement is underway. Good brute force to the rescue. God bless you Arthur.

[@NaturalZBey]

Yo i just spent over 6hrs on this job! Pulled off everything to get it out the way! Ac compressor, p/s pump bracket, tension wheel and idler pulley! Also i removed the alternator & bracket as a unit. Never again!

[@Corndawg99]

What in the hell was that? Did you run out of battery or did you just junk the thing at that point where you ended the video?

[@colin8477]

lmao

[@rustymaximus9179]

Plz listen. Go the next step and do a timing cover gasket, chain, etc. Your water pump is probably fine, it bolts through the cover. That is most likely the problem. I just did my 3rd water pump in 7 years, and it blew out a week later at the timing cover. It's another gasketed plate.

[@astroneptuno1042]

Good work

[@MrDavidelliottjr]

Cant take fan off like that. Clutch in the way

[@utero00oli]

This video is garbage. You did not show how the pulley was removed from the WP

[@RegurgitateEucharist]

I like how its got a k&n sticker on it but it had the factory intake lol XD nice tutorial, thanks for the help!

[@BAND-MAID-USA]

No such word as, unloosen lol. If there was, it would actually mean tighten. HAHAH

[@kimberlyvance6506]

You have a ways to go before being sponsored.

[@MrDavidelliottjr]

Reverse threaded

[@cgfh2396]

I had the same reaction when seeing I was gonna have to take the steering pump bracket apart. Hoped I wouldn't have to but.... Of course I do. I'm working on an 04 Ranger 3.0 and yes same setup. Had to stop before dark b back at it tomorrow morning. Was just lookn around to make sure tht fuel line bracket bolt was the last one. Too bad you didn't finish the video for people tht need the help. Seemed like you knew when to record n not show meaningless BS lol Minus the human error on fan clutch n bolts but that's good - shows character man. Hell I didn't even pull the fan casing. Would b more room to work but haven't needed to.

[@jorgeluv767]

Cg Fh how did you take off the compressor bracket I have one bolt that I can feel but can’t take out how did you do it?

[@geoffreyrobinson9435]

How the hell did yu get the fan out? Special ass tool🤔2 diff 🔧 wrenches🤔or the monkey ass pipe wrench?🤨🤔💭 I've been at this nonsense 4 a solid week now 7th day and all this wasting time so called thinking/gathering thoughts has made me look like an absolute asshole to not have given up on this already🤣