Mecpow X4 Pro Laser Camera Setup

[@mrgrinch61]

THANKS FOR POSTING THIS VIDEO

[@JonGarrison]

Thank you!

[@Fossy35]

Thanks for that Roger it really helps a lot with clear step by step instruction. Where did yo download the new circle calibration sheet from? Keep up the good work. John

[@Fossy35]

Well I’ve set the camera up twice but the captured image is out of focus and when I try to test engrave on a piece of ply it’s about 1/2 inch out of position. Oh well back to the drawing board. I might not even bother using the camera.

[@rogersshop]

It is a bear to get a camera (not just this brand) aligned perfectly and then getting it to stay that way. For me (IMHO), cameras are nothing more than a nuisance and with the exception of my WeCreat laser, where it is required, I don't use them. I have layout grids on all of my lasers and work from Absolute Coordinates, so camera is not necessary.

[@Fossy35]

@ Ah … I have done your layout grid. Perhaps you should do a video on using absolute coordinates for nubies like me! 😀