Mercedes om617 Intake Adapter for Intercoolers

Are you adding a HE221 or Holset T25 frame turbo to your om617? Modifying the intake manifold to accommodate a 2.5" intercooler inlet can be a pain in the a** for most folks. We heard your cries and did something about it!
We offer several Holset turbos, fittings, and adapters for the HE200 series.
The new intake adapter: www.benzforce.com/collections...
Turbos:
- HE200 7cm: bit.ly/2LbWHrc​
- HE221 5.5cm: bit.ly/3nxBN33​
- HE221 7cm: bit.ly/2Xn9rO0​
- HE250 10cm: Comin soon
Installation Kits:
- om617: bit.ly/3pVYHTd​
- om60x: bit.ly/3bkHD5o​
Parts:
- T3 to T25 adapter: bit.ly/3ooaHfK​
- KKK to T25 adapter: bit.ly/3s6zgQP​
- Wastegate kit: bit.ly/2MN04W9​
- 4 Bolt backplate: bit.ly/2L3DGr2​
- 5 Bolt backplate: bit.ly/3oqERz8​
- T25 12AN drain: bit.ly/39eg0rF​
- om617 12AN drain: bit.ly/3noQpl5​
- om60x 12AN drain: bit.ly/3bmvZqq​
- Compressor elbow kit: bit.ly/3nkOM7P​
- Compressor 2.5" adapter: bit.ly/39cTS0R​
- Exhaust adapter: bit.ly/35mRhjX

[@TheRowdyJ]

damn. i was going to get the 200 for low end. might have to rethink my jeep. =)

[@swrvtech]

This is awesome

[@w124mercedes7]

I have a 1987 mercedes 300d with the om603 motor. Do you have a intercooler kit for my car

[@1tapjap]

Do these work with a completely stock injection pumps?

[@dieselbossbrandon]

How much is it?

[@boyddenniston79]

Do y’all still make this adapter?

[@BenzForce]

We have run out of inventory and are not sure if we will produce it again or not

[@awsok1992]

​@BenzForce why? It seems like a great product. I have one on my swap, I havent really gotten around to using it, but I was actually able to use it with long exhaust studs and a spacer so that I could fit an HX30W non intercooled. (I have a stock pump with Alda delete)

[@joegelencser2571]

Why not go with a rubber hose and 2 horse clamps instead of all that expensive bullshit??

[@BenzForce]

I have barb fittings too :)

[@ebenpost3255]

Because some of us lik a clean engine bay and something reliable. Really not that expensive anyways.

[@grizzladams]

Who has actually put an intercooler on their om617?

[@BenzForce]

You better believe it. Bump up the fuel to 90-120cc the EGTs will go through the roof under hard acceleration. The dyno car spikes over 1600F with a pump and stock turbo. That is not sustainable and lowering intake temps help.

[@grizzladams]

@@BenzForce I believe it! But I have seen very few documented online. I'm wondering who has actually done it and how it looks.