Mercury 9.9 Pro Kicker installation - iboats.com

[@Moondog9322]

i was hoping to see how you ran the wires to the battery for the kicker "installation".

[@gerardjones7881]

that screw went into the transom rather too easily for me. A proper lag bolt screw has a bolt head and requires an impact to drive it home. The screws holding my registration plate to my trailer are bigger.

[@burtumstead856]

What size lag screw would you suggest?

[@bearcatdude3993]

How come no bolts in the top holes?

[@MrShark1960]

This 9.9 shaft is 15 " or 20 " ?

[@ew7007]

Did you really believe that little screw that is probably about a half inch into the core of that transom is really doing anything at all? You're joking right? You might want to remind folks to use a good steel cable tether for their motors if they are going to follow your "installation". Get real buddy.

[@timdaniels4707]

Worst demo ever

[@akaitsmedre]

That 9.9 kicker will barely move that boat. I added a 9.9 kicker on a 19 foot basstracker and it was worthless

[@spencerj993]

A 300 on a Lund is crazy

[@ptahX]

Curious if you have a Marine adhesive you prefer for the screws? also if your using a through bolt would we still use an adhesive or use some sort of gasket / bedding compound?

[@Cherishthemoment]

That hurt……

[@Combatkid174]

I would never install using the hardware you used. It will absolutely get loose over time .. Should always be hard bolted.

[@chriszofchak3318]

This certainly didn't provide any good information on wiring and fuel lines for a kicker.

[@t26803]

i was thinking same thing

[@timdaniels4707]

What a waste of my time.