MFT Magazine

[@garywillford]

I bought one. I will not buy another. It is ridiculous that they put that blocker in there and sell it in states that do not have the restriction. The floor plate is almost impossible to get off. In fact, I broke the clips on the back of the plate from having to pry them away from the mag in order to get that floor plate off. Now I have $12 worth of plastic and metal that isn’t good for anything. You got $12 off of me and lost a customer for life.

[@breauxp]

I emailed them and discovered that the floor plate is “sonically welded” in place and that they suggest using a wooden dowel and hammer to free it!

[@JEDIYOUNG]

MFT sux they put a 10 round blocker in their clips

[@SasquatchTX]

I bought one and did a small torture test on it, which it seemed to hold up to. I guess my first magazine didn't have the stupid 10 round block in it. I picked up 3 more, because P-mags were nigh impossible to find and its always good to have spares. I *cannot* get the damn floor plates off to remove the blocks. So essentially I have oversized 20 rounders, which suck. I like 20 round mags that are the size of 20's - they're better from prone position. Why the hell would you put the block in the mag, and not just sell a 20 rounder or 10 rounder for restricted states?

[@savage_the_wild]

How do I removed the 10rd block in the 20/30 mags? Just bought my first two today and that block has got to go

[@Kanuckles]

You cant remove it but you can cut it

[@Wedelj]

Military Arms Channel Maybe grab a few and see how they do in the myriad of 5.56 guns you have? It would be an interesting video, for sure!

[@nc4tn]

MFT should be sued for marketing those 20/30 round magazines for even suggesting that they hold 30 rounds. They are worthless. Academy should be sued for selling them.

[@kilo729]

Did even get use mine. I dropped it and all the rounds flew out!!!!! You even tap on it and it spits out three rounds

[@Kanuckles]

Bottom slide won't come off of mine with the botton pressed

[@mikebuelley7652]

Did you figure it out? Im having the same problem

[@Kanuckles]

@@mikebuelley7652 I forced it off braced one end against a hard surface and tapped on the other side with a hammer until it began to slide, the mag bottom has really tight tolerances so you have to give it some elbow grease

[@SuperAscension]

@@Kanuckles I tried that with enough force to break a finger and still couldn't get the damn floor plate off. I didn't want to put more force in fear of breaking the piece of crap

[@texasrebel832]

Your 20/30 round mags suck mine hangs up and I can't disassemble it to clean it. Waisted money

[@ACYT298]

What rail is that at :30 .?

[@RedArgyleDesign]

looks like a Rebel Arms rail, I think they have updated the look a little since that version but they are still bad ass.

[@andrewjones1610]

garbage ass magazine. 10 round block on new ones, but they still label it as 30 round, now i have to return this trash. should have just bought pmag right off the bat

[@ronjones1995]

10rd block is fucking junk