Micro Air Easy Touch RV Smart Thermostat Install

[@Greghc48]

Great instruction. I think we’ll get one of these. My issue is that I’m not that familiar with my AC / Furnace configuration to know if it is a heat pump, and if we have heat strips. But… I think we’ll be able to figure it out. We have two dometic thermostat units.. one is for an AC only, and the other controls a second AC, and the furnace. Assume two micro air units (replacing 2 dometic thermostats) will work in our RV.

[@bigfred1017]

Thank you! Great video and definitely ordering one now.

[@EddieKeator]

Seems easy enough. Although, I need to be Multi-zone out of the box and have heat pump in Zone 1. Wish your rig had that configuration. Did you test the away from home, remote monitor and temp setting?

[@Jimmy2Tech]

Yes we have tested it and it has worked great so far. Very convenient.

[@thervagenda7193]

I'd like to install this device in my RV but when I uninstalled the old one, noticed it only has 3 wires, green red & white, and the micro air has 6 wires; With my old thermostat I'm running AC and furnace. Please advise, thanks in advance.

[@alexarushmer1217]

Does the phone app let you know if temp goes too high or low?

[@dalepatterson1748]

Yes. The Easy Touch can be configured to notify you if the temperature goes above a set point, or below another set point. Default seems to be 90° Fahrenheit for the high, and 40° for the low.

[@Dora_walking]

My new Micro air ASY -359 thermostat has no installation instruction, I found something on Manuals+ but it say I have to rewire at my AC unit also! Have you ever installed this version (Analolg Duotherm circa 2008 to the new Micro Air 359, thanks for any help!

[@audreybarka5893]

Hi. 2 Dometic thermostats within 3 years crashed! I bought the micro Air but after making sure the wires were correctly inserted the thermostat didn't turn on! I returned it for a check-up...all good...Got it back but still didn't turn on! Can you tell me why? Thank you

[@dalepatterson1748]

I installed mine, today. There seems to be a default delay before it actually activates the air conditioner. It was a little frustrating, I had to be patient, but it came on on its own. I guess it has to seek and find a few things. Also, the five-minute delay on the compressor falls into play, here.

[@dalepatterson1748]

When in doubt, reset the thermostat. Let it boot up, wait a few minutes, and see what it does.

[@sxsoffroad43]

Does this work with heat?

[@Jimmy2Tech]

Correct.

[@sxsoffroad43]

Thanks... subscribed!

[@Jimmy2Tech]

@@sxsoffroad43 no problem. Thank you kindly!

[@rickmcgilvary6252]

Good job. I think i can do this. Thanks

[@Jimmy2Tech]

We are sure you can get it done. Good luck!

[@tammyward3423]

Do you need your own wifi or can you use it with campground wifi?

[@Jimmy2Tech]

You can use with any wifi.

[@josephmcbride8198]

STARTS OFF WITH "BAD INDOOR SENSOR". HELP!!!! THANK YOU!

[@bullboss7698]

Whay if you are camped in an area with no internet service ?

[@Jimmy2Tech]

It will work but with no mobile control.

[@bullboss7698]

@@Jimmy2Tech A lot of places we camp has no cell service. Wouldn't be practical for me.

[@bansheerider619]

@@bullboss7698 It works with bluetooth if you are in range.

[@VV-om8vv]

Thanks for this

[@Jimmy2Tech]

No problem, thank you for your comment.

[@cherryamber7845]

My wifi connection stopped working and I can't figure out how to set up the Bluetooth connection. I originally had it setup, but it isn't working now.

[@JaraadBey]

Did you get it working

[@fortvalor]

I set mine to furnace and it kicks it off to heat pump after a few seconds. Anyone else have this problem?

[@mikehoium8216]

Any codes?

[@Jimmy2Tech]

We have not had any codes.