Repairing a Paslode 5300 Framing Nailer

[@Mikeattempts]

Sleeve Seal & O-Ring Kit (PN: 402011 ): www.ebay.com/itm/160960366740 Bumper Post (PN: 500453 ): www.ebay.com/itm/231412921074 Snap Ring Pliers: amzn.to/3eHsQ5l (affiliate*) *Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!

[@tombrownrigg8794]

Thank you very much Sir 👍

[@Mikeattempts]

Thank you for watching! :)

[@kisauer]

Thanks for the video. Helped a lot.

[@Mikeattempts]

I'm glad it was helpful, thanks for the comment! :)

[@ronniefoster5099]

Hi Mike. Great Video. I have the same nail gun, but the follower spring was removed and I can't seem to find a manual that shows the same magazine I have and can't figure out how to install it. When I look up 5350/90S, the magazine in the image looks different. Did you obtain a manual that shows your magazine assembly? Thanks.

[@Mikeattempts]

I don't have a manual that shows this exact magazine either. I'm no pro but, If I remember correctly, I think the magazine spring is just roll of flat metal that turns on a little drum. If you remove the magazine from the gun, you should see where the drum mounts at the top of the magazine. The end of the roll attaches to the follower.

[@michaels5842]

Hi Mike, I have a old paslode coil roofing nalier. Any videos or info to pass along. I need parts.

[@Mikeattempts]

I don't currently have any coil nailers or I would happily make another video. My advice is to just take it apart, find and order any broken parts (usually just seals and bumpers), replace all of the O-rings while you're in there, and put it back together. :) eBay and Amazon are good sources for parts. Let me know how it goes!

[@timfruge3911]

How much is that whole kit for you rebuild that right there

[@Mikeattempts]

All the parts were around $26 plus tax.