You make it look so easy Mike. Thank you for sharing. Have a great day.
@MikePeaceWoodturning3 жыл бұрын
Thank you too, Glen.
@ValioMadre73 жыл бұрын
Thanks for sharing, please keep them coming.
@MikePeaceWoodturning3 жыл бұрын
You bet!
@jackthompson80193 жыл бұрын
Great tutorial Mike. Thanks a lot.
@MikePeaceWoodturning3 жыл бұрын
Glad you enjoyed it!
@jeanlong42853 жыл бұрын
Thanks for all the great info.
@MikePeaceWoodturning3 жыл бұрын
Our pleasure!
@LewisKauffman3 жыл бұрын
Thanks, Mike! Threading is something I'm gonna have to try and learn.
@MikePeaceWoodturning3 жыл бұрын
You can do it!
@bernardfutter6503 жыл бұрын
Thanks, Mike; I've been making paired threaded annuli for stock, and trimming to outer diameter at point of use. Much more efficient to fit the collar and then thread it, as there is still chance to take corrective action if chasing hits a snag. Bernard.
@MikePeaceWoodturning3 жыл бұрын
I agree. And that is the way I probably should have shown. But collars are so easy to thread compared to a box lid, I rarely have an issue.
@joecrocker89303 жыл бұрын
Mike, I've never done any thread chasing but I would like to try. I have some exceptionally hard and dense oak that I think would work for thread chasing. But I don't know. If I send you some will you try it? No strings attached. Please reply and I'll get it in the mail.
@MikePeaceWoodturning3 жыл бұрын
Thanks for the offer, but No. The wood needs to be a ring diffuse wood like Pear and not a courser ring porous wood like oak. Hardness is one factor but it also needs to be a very tight, straight grain.
@joecrocker89303 жыл бұрын
@@MikePeaceWoodturningI know I said this wood is oak but I'm not sure. I got it from a large old half rotten stump. The grain is very tight. After cutting on my table saw the surface looks as smooth as glass and it's very hard. I'm in north Florida so I don't know what else it could be. I think you should try it.
@Amybaumgart3 жыл бұрын
Do you think 10tpi might be easier or more difficult than 16tpi? I have not had any luck with getting good threads with my 16tpi.
@MikePeaceWoodturning3 жыл бұрын
More difficult for sure. courser threads are always hard to chase then finer threads. For 16tpid you need very hard wood. What wood are you having a problem with. Did you watch this video kzbin.info/www/bejne/oWjHg5Zvd7afqdE
@monophoto13 жыл бұрын
I noticed that you glued the wooden insert into the urn before enlarging the opening and cutting the threads, but when you were illustrating use of plastic/corian material for the insert, it appeared that you were threading the insert before glueing it into the urn. Could you expand on that choice? It seems to me that it might be safer to cut the threads in the insert before glueing it in so that if there was a problem with chasing, there would be an option to toss it in the burn box and make another insert. (My failure rate is such that I always expect disaster!)
@MikePeaceWoodturning3 жыл бұрын
You have a valid point about completing the insert with thread before adding to the vessel.