Watch our CNC 5 axis mill run a first operation on some hood hinge brackets!
Пікірлер: 13
@dustinwalden709114 күн бұрын
Was this the first time running it? Tons of room for improvement.
@LilyJiang-y3j18 күн бұрын
very good😊
@Eggsr2bcrushed10 күн бұрын
Yea I'm hammering those out in under 10 minutes on a machine that costs 1/2 as much.
@cgpmachining14 күн бұрын
So you use a 5 axis mill so it can clean the pallet off after your done machining the parts?
@wrighty3388 күн бұрын
i got to the end and realised too 😂
@pr0xxiii24313 күн бұрын
was this programmed in PowerMill..?
@CVF_RACING12 күн бұрын
TopSolid
@wrighty3388 күн бұрын
your machine needs a clean....
@CVF_RACING4 күн бұрын
Agreed!
@mjshorty1911 күн бұрын
No offense to whoever programmed this, but to have this terribly optimized program running in a robotic cell seems almost criminal. I could make those parts in conservatively, 40% of the time
@wrighty3388 күн бұрын
I see this often on here and im not even a professional programmer or machinist. There's some process optimisation to be had here i think.
@mjshorty198 күн бұрын
@@wrighty338 being a programmer for the last 7 years and only being 29 years old, I'm aware I don't know even close to everything about machining. But I tend to think I know what I am doing relatively well and I would never in my wildest dreams put a program like this out into our shop to run a production part
@CVF_RACING4 күн бұрын
This video is for customers that have asked to see machined parts in action. To eliminate coolant spray from getting on the camera, sacrifices in speed and efficiency need to be made. We are not trying to show off here 😁