Minelab's GPX6000 on the hot rocks

  Рет қаралды 698

Moneybox

Moneybox

Күн бұрын

Пікірлер: 10
@Maxkil
@Maxkil 9 ай бұрын
I really want to go detecting for gold
@cristian-marius-albu
@cristian-marius-albu 7 ай бұрын
Hi. Same problem with PI in areas where a lot of iron hot rocks exist. My SDC2300 was screaming, couldnt use it. Surprisingly the Gold Monster 1000 in discrimination mode can see those hot rocks, show the sign towards iron but not making any sound. I was able to detect with a VLF.
@mitchellpaterson7062
@mitchellpaterson7062 Жыл бұрын
That’s some really hot ground
@prospectorpete7005
@prospectorpete7005 Жыл бұрын
Hi Phil, might be best to try the 14" DD coil in that ground, it's a fantastic under rated coil and should handle those rocks better than the mono.
@goldfools5445
@goldfools5445 Жыл бұрын
Yes, correct. I have put it on when the hot rocks are a bit noisy. Still sensitive to small targets and will ping deeper bigger targets. Will top out about 10” on a 5g where the 11” mono will punch a bit deeper. Mind you we are in Leonora, that ground shown might be more difficult to balance on. I know I can get mine to run dead silent on the laterite and basalt. I bit noisy on the magnetite iron stone. I wonder if the 6000 in this clip has a problem. It has been an issue on the early machines. Although I have spent a fair bit of time with two of them without issue.
@moneybox5733
@moneybox5733 Жыл бұрын
@@goldfools5445 Yes the DD does make a diference on bad ground but these ironstone rocks give such a sharp signal there seems to be no fix for it on the 6000. This is my new 6000 supplied by Minelab under warranty recently. The old machine was trouble from day one but I put up with it for nearly tow years but after one repair and four coil failures Minelab replaced the whole unit and this is a much better detector.
@moneybox5733
@moneybox5733 Жыл бұрын
When on the patch at Naneen we had two 6000's and tried both coils. The GPZ7000 and GPX4500 ran reasonably well over the same ground where the 6000 couldn't be used.
@topendgold9284
@topendgold9284 Жыл бұрын
That's why I love my zed Phil. It still gets noisy, but in some ground the 6 is too sensitive and thinks everything is a target
@ILOVETHEHIGHCOUNTRY
@ILOVETHEHIGHCOUNTRY Жыл бұрын
Each to them selves, hot rocks. I just swing very very slow and not to use the stock coil. Try hunting those places before sun hits them.
I found GOLD with the MINELAB GPX6000 and 12 x 7 XCEED coil KILLER COMBO
27:32
“Don’t stop the chances.”
00:44
ISSEI / いっせい
Рет қаралды 62 МЛН
So Cute 🥰 who is better?
00:15
dednahype
Рет қаралды 19 МЛН
Metal Detecting - GPX 6000 - How good is this Machine?
23:15
Gold Fever Adventures
Рет қаралды 3,4 М.
They’re Not Always Hot Rocks
7:02
Les Gold
Рет қаралды 6 М.
Minelab gpx 6000 with the gpz 14 coil. Scrapping and detecting.
15:21
Jenko’s Gold Adventures
Рет қаралды 2,4 М.
How to Calibrate the Minelab GPX 6000 for Gold Prospecting
15:15
Complete Prospecting
Рет қаралды 8 М.
Testing the GPX6000 in noisy ground
8:50
Smokey Prospecting
Рет қаралды 2,1 М.
Gpx 6000? Gpz 7000? or Gpx 5000 modded? YOU DECIDE !!!
29:36
Eureka Gold
Рет қаралды 15 М.
GPZ 7000 Coil Shootout -  Nugget FInder Z search 17"x13" coil vs Minelab 14" Coil
9:32
1000 Year Old Tree
32:39
Blacktail Studio
Рет қаралды 1,7 МЛН
Deep Aussie Gold Ep 4 | GPX 6000 is UNBELIEVABLE
27:59
Goldfields Goose
Рет қаралды 32 М.
“Don’t stop the chances.”
00:44
ISSEI / いっせい
Рет қаралды 62 МЛН