Mini Bandsaw review and testing // Scheppach Hbs 20 // +How to make a simple Pushstick

[@Franco_NI]

I have had this band saw for 3 months, make sure you purchase a spare blade as the 6mm 6TPI that comes with it will break if you cut pine wood around 3/4 thick. I had to purchase a 12mm 4TPI for this. Make sure you balance the blade in the middle of the wheels and if you can... bolt it down as it does shake a bit.

[@Franco_NI]

@stimmo77 The 12mm blade is good for cutting 11" clock circles but for cutting curves I in 3" soft weed I would go for a 10mm blade.

[@SamanthaStephenson-di1qo]

Hi I don't suppose you know what that black plastic thing is near the blade do you? I've got the same one and it's snapped and need to find replacement

[@sinansalimov980]

Great review 👍. Is it to noisy?

[@niallchurch2679]

I have the basa 3 and scheppach don't supply a power cable with it,and everytime you adjust the blade guard up or down for the height of wood to be cut,you have to reset ALL THE BEARINGS!

[@mycellarworkshop5822]

Actually I also had some problems with my bandsaw but nothing that big. Maybe you can try to reclaim it...

[@malmal5158]

bracelet on wrist with hanging threads is a no no close to blade

[@jordee7069]

Watts ? Noise ? from one to 10

[@lamproknives]

Great ! I have a few questions : -what's the price ? Would you recommand it ? I'd like to buy a bandsaw to cut knife scales in half because they are too thick, how will this bandsaw perfom in this task ? How flat are the pieces once cut, and how thin can they be ?

[@mycellarworkshop5822]

Hi. The price is about 148Euro. I would recommend it for small workshops but it works very well and can cut wood 8cm thick. Of course it can cut knife scales (just yesterday I did it). The cut is quite smooth when you use a fence but you definitely have to sand it a bit. You can cut 1mm thick veneers using this bandsaw.

[@lamproknives]

@@mycellarworkshop5822 okay thanks a lot for your answers ! Keep up the knife making project, you're doing a great job ! Got yourself a new sub 😉

[@mycellarworkshop5822]

@@lamproknives thank you! I will upload it very soon. 😊

[@lamproknives]

@@mycellarworkshop5822 I also have a channel by the way, much smaller than yours tho 😉

[@mycellarworkshop5822]

@@lamproknives Yeah! I'll definitely watch some videos.

[@wac36]

Would this be ok for 3mm thick steel sheets?

[@mycellarworkshop5822]

wac36 I dont think so. Maybe if you would buy some metalcutting belt.

[@oskarkluson9256]

very nice machine

[@ndeco2]

This saw can only cut 8 cm thick wood. Is there a trick, hack, way, to increase that thickness, height? 10, 12cm...

[@lolwhittingham]

I have to say i got more beneficial information from the comments !!!!

[@mycellarworkshop5822]

Hi I am sorry if the video wasnt’ enough for you. Do you have any question about the saw?

[@lolwhittingham]

@@mycellarworkshop5822 Hi,My comment was not intended as a criticism of your video. But on reading through the comments , I did gain a lot of helpful info. read the one beneath from "Frank" for instance .

[@keto4life197]

Sounds like a cat in a rut