Mitsubishi L200/Triton Automatic Gearbox FIXED - Watch this 1st !

[@simonmac6910]

I am so glad I watched this video, just bought one just like this for a grand and it was the same problem 💷💷💷. Thanks guys

[@L663]

You sir owe me a drink !

[@scottred6313]

That’s crazy. My 07 Triton just lost 2nd gear and reverse. And with flashing D. I’ll be doing this wiring inspection first before I pull it out. Thx for the video guys.

[@L663]

I am praying for you that its the same problem !

[@christianmorton814]

Massive thanks mine did the same today was told by garage its a big job to fix maybe a new gearbox. Took me 10 mins to fix. Thanks again

[@L663]

Well done - saved yourself some money and saved the environment with wasting a good gearbox etc !

[@ManBikeSwag]

Thanks guys! You just saved me thousands! My problem was exactly this!

[@L663]

So cool this video is still helping people !

[@gulwantgill213]

Mitsubishi colt is intermittent jerking when driving any idea what it might be and quick fix? 🙏

[@Hongzbengkelspesialismatic]

thank you for the uploaded video, good luck always and always healthy greetings from Indonesia

[@theodoreholland559]

Hello . Thank you for this video. I am an owner of a 2012 Mitsubishi L200 with an automatic transmission gear box. And here is the problem . As I am driving at a normal speed of 80 km/hour -55 miles/h , often stepping away from the gas pedal and let the car go due to traffic, then the car breaks suddenly 2 times and moves from the 4th gear to the second gear. After that it is stucked on the second and I cannot accelerate, the D indecator flashes, and the only way out is to pull over and switch off the engine and started again. Do you have an idea what is causing it ? Can anyone help ? Thank you

[@preslavvasilev7387]

Thank you, very much. Saved me a lot of time!

[@L663]

Glad it helped!

[@njfishing1917]

I also have issue with my Mitsubishi l200 but mine is 4n15 5 speeds auto. My car jerking from gear 1 to 2 when at warm temperatures or drive slow, especially at traffic jam. But it's changed smoothly when i just start driving at morning or drive fast. Till now donno what's the issue 😢

[@L663]

Try and oil / filter change ?

[@ASCarvings]

Interesting vids guys. Keep them coming

[@Fishingguy90909]

Got a 2012 l200. Has a similar problem. When the engine has run for a bit and I drive down hill, I can feel a pull (only way I can describe it) and it jumps into a gear and stays stuck in it. The D on the dash flashes. This clears when I turn off the engine and restart, until I go down hill again. Could this be the same issue?

[@L663]

Its worth a check... 10 minutes to check...

[@marcelracak9372]

Hi a have the same problem what you did to fix this ? Please help 🙏. I got new transmission and also torque converter and is still the same thanks for any help.

[@sanboytv6564]

I have also that problem anyone guys fix it

[@khairilthegreat]

Hi, I got the same issue. D Flushing. Do you manage to fix the issue, how?

[@luisabrahamarayazamora9003]

@@khairilthegreat did you solve the problem i have the same damage

[@stevenbund6641]

Was it just the yellow wire

[@johnnytyj1]

my Triton having the same problem..that was inhibitor switch...removed and cleaned it ...it will work well...

[@wanhokage1793]

It's work 4 u??

[@danleaker8714]

Hi, did you replace a short section of only one wire or did you find other damaged wires? Is there anything you put in place to stop it happening again? I have the same problem but it’s intermittent and tends to happen over long journeys or when towing. Thanks.

[@L663]

I just replaced the one wire and then added a lot of insulation tape to relieve the stress and vibration and protect the wires

[@danleaker8714]

@@L663 thank you.

[@IrnBruFreak]

I had this issue - sadly the auto gearbox specialist and Mitsubishi couldn’t find the wiring issue and the gearbox imploded via the torque convertor. £4000 later I had a reconditioned gearbox. 8 months later the symptoms started again - this time the mitsubishi garage was able to identify the problem and I opted for a complete swap out of the wiring loom leading to the gearbox and that fixed it finally. Wouldn’t be surprised if this was the exact issue. When this initially happened all the mitsubishi / autobox specialists didn’t have a clue

[@mirceavalcan4039]

Hello! I have error 1782 gearbox 4. What can i do? And stop D flashing. Thank you

[@yaqubasif9378]

Can I change 2009 gearbox to auto is it possible will I have to change ecu

[@Brian-ie2un]

Well that's a potential $4,000 saving as many a garage would be dismantling the gearbox quick as.

[@arnoldjr.tegui-in3149]

Mine stucked at gear 2? Might be the same problem. You need restart the engine.

[@waynewatkins7287]

Hi all my 2010 auto the selector is realy stiff an cant select drive any help please

[@brimleyhillmassive]

Just got the gearbox back, cost thousands, i wish id checked this first

[@L663]

Ouch !

[@anthonyalekhtiyar4693]

Hi mate my Triton slips out of D and the little screen in front of me where normally reads my gears goes blank. Could this be the same problem? Engine light also turns on.

[@L663]

Depending which wire breaks the problems can vary... but take a look at the condition of the wires... it will take you 10 minutes

[@lukejaber9945]

hey bro did you end up fixing it i have the exact same issue literally the exact same

[@sicariodon5152]

Did you fix it bro

[@tripvida]

HI i have a l200 2006 elegance my auto gearbox shifts gears smoothly on drive but i have noticed when i stop it downshifts to 1st gear very hard i can feel the knock also it sometimes stays in 2nd gear i can feel a slight vibration and when i press the accelerator pedal it disappears. what could it be?

[@L663]

I would check the wiring loom first ... then change the oil... but it sounds electrical issue

[@tripvida]

@@L663 wiring loom as in the engine ECU loom or the transmission wiring? ive changed oil including oil filter.

[@pesohernandez1091]

thanks for the video Moss

[@L663]

No problem 👍

[@pablovargas8333]

same problem over here but mine is 2016 model. You guys think this solution will apply?? to mine? please help.

[@L663]

you should check the wiring for damage !

[@waynewatkins7287]

@@L663 hi m8 my 2010 auto the selector is realy stiff an struggling to find gears

[@nazzriehaslan]

Hello my gearbox cannot inside D gear when cold and jerking

[@L663]

Hi - I guess an oil change would be the best starting point here.... as its OK when warm its not an electrcal problem. The oil is the only think impacted by temperature

[@nazzriehaslan]

@@L663 ok tq.I try to change an oil first? I will text u again

[@johnmorgan8413]

We're the sencor on Mitsubishi triton 2002 in limp mode

[@chrisdonnelly7401]

snap on you have to switch key off then wait 15 seconds to disconnect

[@rayjones3473]

Nice mitsubooshi

[@wanhokage1793]

My car flashing D,and stuck at gear 3....but when i turn off engine and start back..evrthg back to normal..

[@L663]

Your problem sounds the same as mine exactly - i would be checking the wiring if i was you !

[@wanhokage1793]

U car also prob lke me??

[@jmjrrosaroso4644]

How can you fix the problem? You check the wire?

[@wanhokage1793]

I check wre,bt stll same..all wire ok..😭

[@marcelracak9372]

Hi please help me I have the same problem. D starts flashing and I'm stuck in 3 gear but I can down shift when I restart the engine it is fine but will do the same after a couple of kilometers

[@chloeg8813]

😊😊😊

[@leemorris93]

I need a bit of help my l200 only moves in reverse I have changed the inhibitior switch and that did nothing I also looked at these wires and there fine

[@L663]

Sorry cant think of what this could be - you have tried the most obvious things.

[@mirceavalcan4039]

Hello! I have error 1782 gearbox 4. What can i do? And stop D flashing. Thank you

[@L663]

it could be many things !