Surface Finish Measurement - Skidded VS. Skidless Surface Roughness Measurement

[@SteveToccoDrummer]

All the Mitutoyo videos are very helpful. Thanks for making them so easily understandable and available.

[@sushmautnoori5596]

What is the applied pressure from the stylus?

[@EricK-h9f]

I’m trying to get the model number for a drive that is side to side usually use for grooves I’m having a hard time finding this

[@josephlecheminant2231]

what are example applications of the .75mN detector vs the 4mN detector?

[@josephlecheminant2231]

would these units work well on non-machined surfaces? such as cast, or powder bed fusion 3D printing?

[@kennethchan7223]

How to measure the roughness for the spherical surface?

[@balaji1679]

Why don’t we used skidless probes for all the roughness measurements. It can be measured all the types of profiles right..?

[@USMANALI_Videos]

Very nice information 👌

[@MitutoyoAmerica]

Thank you!

[@kamalpal7730]

Hallo sir in our lab there is a SURFTEST SJ- 210 of Mitutoyo. Now when I trying to start show Returning massage can you halp me what can do. If you make a video on that if possible.

[@harinanda02]

Many customers requires calibration for roughness specimen.please advise the scope for the same

[@manikg7280]

I want know, any measuring instruments for sand blast finish checking if any kindly give suggestions

[@guildtitan]

Hello, there are two types of stylus .75 and 4nM. Can you explain why will one choose one over the other?

[@MitutoyoAmerica]

This is for Surface mesuring equipment .75mn is the measuring force. Please view link www.mitutoyo.com/wp-content/uploads/2012/11/1984_Surf_Roughness_PG.pdf

[@465maltbie]

Old video but nice to see, didnt know about that. charles

[@MitutoyoAmerica]

Thanks for the comment! Glad you enjoyed this, we have many more videos to check out and we should have new content coming soon!

[@saurabhbabu1510]

Is it correct to measure surface finish along the circumfrence of Clyindrical job having dia approx 86 mm using a skided Mitutoyo SJ 210 instrument , by plunging the stanadard mitutoyo detector stylus combination by approx 1.0 mm using height gauge inorder to acheive positive contact with the surface ? Surface finish requirement is Ra 15 microinch . Need reply from Mitutoyo, asap !!

[@saurabhbabu1510]

Checking parameter : Cuttoff length : 0.8 mm No. of samples : 05

[@krnika4047]

Very informative thanks.

[@MitutoyoAmerica]

Glad it was helpful!

[@sukranochani5764]

nice thankyou

[@MitutoyoAmerica]

You're welcome.