3 years down the line and still great help, thanks alot!!! worked perfectly on my mk2s.
@ilkalco10 жыл бұрын
It is correct that RIGHT hand ground would be more proper because some cartridges already have a connection to ground on the right (RED) RCA. Two grounds in this case could create a induction loop (AKA Ground Loop) and hum. Also a good reason not to wind up the ground wire and stick it in the wire compartment. In the video Mixaddicts loops the wire in a coil (BAD) but then winds the wire around the coil to keep it secure (Good) and that action helped to cancel or disrupt any ground loop. My suggestion would be to cut the ground wire as short as possible and soldier it to the Right channel ground. That ground wire is attached to the cricket board mounting screw next to the Right channel ground. Be careful only to cut the wire that went out to your mixer. There are two wires attached under that screw and you don't want to cut the wrong one.
@djvik114 жыл бұрын
Muy Bueno tu aporte a la red! Muchas Gracias!! desde Argentina Dj Vik!
@MrMikkiFunk13 жыл бұрын
On one of my 1210's the ground wire is just not there. What if I open it and its been ripped out completely? How would I go about replacing it?