Model Build: Yndrasta

I bought the Stormcast Eternal box set SPECIFICALLY for this model. The others are awesome too, but I really needed her. She's one of my favorites, though not necessarily because she was fun to build. As a push together model, there were some unnecessary challenges that I'll talk about in the video.
Thanks for stopping by!
Connect with me
---------------------------
/ societycasefiles
/ societycasefiles
/ gothicmalevolence
Links & Store
---------------------------
linktr.ee/soci...
roberthazelton...
Difficulty: 4.25
---------------------------
The difficulty rating is based on a scale of 1 to 10. 1 being extremely beginner friendly, and 10 being some of the hardest models I've built.
90% of Yndrasta was not difficult to put together. But cutting her out proved to be a bit of a pain. I can't say for sure I did it (and I'd happily admit it if I did) but one of the pegs for the foundation was not there when I dry fit the model. So either I cut it off, or it broke before I got to it. I didn't see it on the sprue.
Then, there's the wings. By the time you get to that point, you've done a lot of easy stuff. Difficulty 3 stuff, I'd say. But then the wings. They did not fit as I think they should've. And when I did them wrong, they touched her weapons, which is a pain for painting. And I'm 99% sure they didn't intend for that to be the case. So I had to wiggle it around to get it to work.
Just because it was fussy, and there are some strange contact points and the weapons are thin and would be easy to break, I elevated the difficulty. And one last factor comes into play: cutting her out. If it had been easier, then it would get a lower difficulty.