Motorcycle dash on your phone with OBD II reader

[@hiddenskies8805]

This is exactly the video I needed for my KTM thank you!

[@nickn7939]

I have the blue driver on my mr2, It's funny I was always wondering if there was a way to get it working on a motorcycle, now it's confirmed, thanks for the vid!

[@drainmonkeys385]

Carpe iter makes the best tablet for this.. and they have a nice app called DMD2 for android. Allows you to pull off all the data your ecu will produce just like this but all readable from the app … the tablet is military grade,, you can hard wire to the motorcycle.. it’s the best… better than using the phone.. the phone has no vibration protection…

[@josuetop8069]

Hello, where i can find it?

[@drainmonkeys385]

Carpe iter makes the best tablet for this.. and they have a nice app called DMD2 for android. Allows you to pull off all the data your ecu will produce just like this but all readable from the app

[@corybass4713]

I have a 2020 KTM 790 Duke and tried about 4 OBD readers along with a series of different apps including the Blue-Driver with the exact cable adapter you have. I just found your video though. All the readers "connect" to the bike but none can seem to read the data- protocol. Any help or ideas would be amazing!

[@Gabbagoool]

2 years 2 late but if ur 0-4 it might not be connected properly if ur following the proper hook up procedure, maybe a short or dust or sum. u ever figure it out?

[@themosaito]

Hi, Thanks for the video! I have a 2018 KTM 690 Enduro. It wasn't shown on your video, but do you get full functionality with the BlueDriver? I need to read the MAP Sensor and the Throttle Position Sensor, and I don't think these were covered in your vid. Do you know if these actually work?

[@mjaworley]

What adapter did you get to work on your harley? Is it a 4-pin or 6-pin connector?

[@ektalon1]

Can you clear codes and “service needed” warnings?

[@loskie9389]

Wondering the same thing…dies it allow user to clear codes?

[@maxw576]

​@@loskie9389 a little late, but yes I've cleared and read codes with the blue driver.

[@davisjayy]

Would this work with a hayabusa? I found the correct connector to obd2

[@nd5977]

is this compatable with the truimph tiger 800 xrt

[@rishi-9-00]

Can i keep the obd scanner connected to my bike all the time, also while riding ?

[@AverageCarGuy]

Yes. You can.

[@rohrfacu6228]

Hi there! Is this device compatible with all motorcycle brands?

[@primal5435]

Bluedriver comfirmed it works on a few bikes, but they dont promise it workning on all brands and models. However, it's likely that it will work on most bikes

[@citygs]

does this drain the battery when not in use?

[@primal5435]

Pretty sure the connection turns off with the bike. So I would assume no.

[@BradleyGibbs]

Does bluedriver only work on bluedriver sensors or does it work on any ELM327 device?

[@AverageCarGuy]

The app only works with their own device. Is that what you mean?

[@Bunk_Moreland]

do ELM 327 firmware v1.5 work on new motorcycles (2020 and later)?

[@anthonypolitis4828]

not working to my gsxr k9

[@AmirHosseinFZ]

I wanna buy it, Did you try it?

[@markanderson1518]

Do you have the link for the adapter?

[@AverageCarGuy]

Yes. It’s in the video description.

[@julianarodriguez3635]

How about for scooter

[@BradleyGibbs]

Only if the scooter has an ECU with obd2 output

[@gensanmotorcyclesolutionsg3404]

What application is this

[@BradleyGibbs]

BlueDriver

[@texasaviator]

So what is the app name?

[@_JimS]

"Blue Driver OBD2 Scan Tool".....who knew...Lol!

[@HellaLegitFoo]

@@_JimS Whoa I’d have never guessed! 😂

[@_JimS]

@@HellaLegitFoo Right?

[@raptor6958]

I accidentally did a burnout with tc on and now i have check engine do u think i can remove it with this device?

[@AverageCarGuy]

You can at least find out what it’s complaining about.

[@ToHungDuong]

what's app name? thanks

[@topmastermind]

Ay mandaw ka uyam