Mounting an xTool Screen Printer Frame on an Xtool P2 CO2 laser

[@AlexVieira-ey4oi]

Thank you for doing all the leg work!! Super helpful

[@Celticlo]

Just got my multicolour kit today for my P2 and was thinking very similar

[@andredempsey2687]

Great video. I’ve been looking for good information on using P2 with screen printer and found it here! Thanks

[@d-sx560]

Nice. You might consider adding a small air pump to increase the pressure inside the box to get better fume dispersion.

[@ThomasLacroix-b2u]

I ordered month ago and I never received it lol

[@Zentient1]

Contact [e-mail] they should be able to track down your order.

[@bigleverglobal2180]

Great info, thanks for putting it out.

[@GiulioMosca]

Thank you so much for this video! It was very helpful!

[@eross21]

how do you keep the tray from sliding ?

[@Zentient1]

I just push it left and to the back. I could also create some type of wedge lock to affix the tray, but so far have not found it necessary

[@sora7827]

How many watts does a Co2 laser use?

[@Zentient1]

I added a 1000 watt UPS to our demo room. I was not so much concerned about long outages, but I didn’t want a momentary power drop to shut down a running job. I did a little testing to see what power draw is for the P2 and the smoke purifier. P2 on idle ~70 watts P2 cutting at 100 percent power ~450 to 470 watts P2 job paused (fan running), or when waiting for exhaust to complete at end of job ~104 to 114 watts Smoke purifier 1/2 position (indicator aligned with red LED) ~120 watts Smoke purifier full power ~180 watts

[@eross21]

i am at work and don’t have my frame. but i am making an alignment jig with pins? do you know the measurement between the center of 1 pin, to the center of the other alignment pin. thanks

[@Zentient1]

The pins are 181mm center to center. And my pins measure 5.1mm in diameter

[@Zentient1]

Xtool also has an xCS project for a P2 frame fixture that can be cut on the laser.

[@eross21]

@@Zentient1 ahh you are awesome!!! thank you so much. now I can finish my jig here at work. that made my day. thanks

[@eross21]

@@Zentient1 xCS project? where is that? on the website ?

[@Zentient1]

@@eross21 projects.xtool.com/howtos/4614