Mr Bullet Feeder | Fixing Upside Down Bullets

[@robmiskowitch6344]

THANK YOU!!!!! You just helped me fix the same problem. All bullets are sent down the spring the right way now. Great video tip.

[@Comerelaxandlearn]

Glad I could help!!

[@robmiskowitch6344]

@@Comerelaxandlearn Your timing was perfect, there was so much set up and tuning. It was nice to find your video and resolve this so quickly. 😀

[@TheRotorhound]

Always fascinated at that design.

[@Comerelaxandlearn]

same!

[@suleymanwilson8919]

Thanks to you, this solved my problem of face down bullets. Thanks for the great advice. I am using a Dillion RL 1100 and when everything is set right it turns out a ton of ammo quick. I have had to keep a constant eye out for face down bullets. Your video is a great help. Thanks again! :) 😁

[@Comerelaxandlearn]

Glad to be of help. Hey subscribe if you can.

[@rangervapes571]

The tilt of the feeder will also allow you to have less of a ledge, especially important with hollow points and wadcutters.

[@Comerelaxandlearn]

Very true. Thanks

[@sjbriggs323]

That did the trick. Thank you!

[@Comerelaxandlearn]

Glad I was able to help!!

[@WvMnts]

Thanks for sharing!! Mine will run flawless then as soon as your not paying attn I’ll get a 9mm nose down. I’ve never figured it out yet. I’ve adjusted/fine tuned until I gave up

[@Comerelaxandlearn]

Just keep adjusting it. Don’t give up

[@Av8orDave]

You can set them without it even running. Running at slow speed, stop it when a notch is just over the start of the spacers. Adjust it so that the tip of an upside down bullet misses the ramped edge of the spacer, but a correctly oriented one sits on top of the edge of the spacer. Then it won't flip correct ones, but will flip upside down ones. You'll be able to get it with 2 adjustments at most.

[@Comerelaxandlearn]

Thank you! Hey, please consider subscribing if you can!

[@assassin40oz]

Thank you!!!

[@Comerelaxandlearn]

Glad to help man!!

[@markpaztv2289]

Hi, wher do I get the stand alone for bullet feeder? Thank you in advance

[@Comerelaxandlearn]

It’s a pipe I bought at Home Depot

[@albertthesecond210]

Slips and falls from chairs used as ladders are a leading cause of injuries.

[@Comerelaxandlearn]

True dat. But I am vertically challenged. lol hey consider subscribing if you can!