Mt09 Gen3 Exhaust Mod

[@andrear629]

Did you remap Ecu after this? Did you remove cat? Thanks. Good sound man!✌️😎

[@arnoldelliott5695]

I did not remap

[@tiagoandre7464]

Hi mate, did you notice any difference in the resonance level in the sound? I made this modification and I confess that at a certain speed the resonance is quite intense thanks

[@arnoldelliott5695]

@@tiagoandre7464 if i remember, i think mine was fine. I only had this exhaust for another few weeks before i purchased an aftermarket system.

[@tiagoandre7464]

@@arnoldelliott5695 thanks mate

[@Moondyne_Joe]

​@@arnoldelliott5695why did you end up getting an exhaust didn't like the sound overall?

[@arnoldelliott5695]

@@Moondyne_Joe i did but i liked the look and little louder sounds of the aftermarket.

[@Moondyne_Joe]

@@arnoldelliott5695 what did you end up getting?

[@raisingcane225]

Thanks for this video. I know you now have an aftermarket exhaust, but do you happen to have any additional sound clips of the modded OEM exhaust? How much louder than unmodded would you estimate it was? I am thinking of doing the same mod, as I want it moderately louder than stock but not anywhere near as loud as a full and cat-less exhaust. Any feedback you can provide is much appreciated.

[@arnoldelliott5695]

I dont. But it’s perfectly in the middle. Alot better tone and a touch louder. Perfect for free

[@raisingcane225]

@@arnoldelliott5695 Thanks alot. My ‘22 XSR 900 should be arriving in about 7-10 days and I plan to do this mod. I can afford an aftermarket, its just O find them all too loud for my tastes and the OEM un-modded too quiet. Will try and record a few “before and after” sound clips - both at idle and revving while stopped as well as driving past the microphone in a stationary position around 50 mph and lastly with the mic on the bike while riding around. I’ll put up a separate youTube video on it and credit your vid here also.

[@ToxemicHunter]

Is this with the fiberglass packing still installed or did you pull it out through the balance tubes?

[@arnoldelliott5695]

Fiberglass is still installed.

[@itzgodlikexsexe6067]

​@@arnoldelliott5695 i wonder how much a difference it would make if you got rid of the viberglass

[@lorenyost5877]

Thanks for the tip, just did it today and it's perfect!

[@arnoldelliott5695]

Seeet🤙

[@davidd6849]

Hi again Arnold Eliot,I know I’ve asked you before but winter is upon us(canada) I read you put a miiv exaust. You liked the OEM mod ? I would like to put the Akrapovic under exaust like the older generation 2000$ Canadian but they don’t make it for the 2021 and up model. So option 2 OEM mod maybe. Thank you for your time.

[@arnoldelliott5695]

The mod is definitely worth it. I really does make a big difference. Now that i have the Mivv, i really enjoy that exhaust too. I bought it from motostorm in italy and came in less than a week.

[@gpinberwick]

I've just put the Mivv on mine and get a buzzing in my helmet at low revs. Do you have anything like this? Love the look of the Mivv though@@arnoldelliott5695

[@brudalerSVRider69]

Short question :) - Stainless Steel for welding?

[@arnoldelliott5695]

No sadly i didnt. However the welds surprisingly havent rusted.

[@brudalerSVRider69]

@@arnoldelliott5695 therefore i assume the exhaust itself is not Made from stainless steel :) - thanks 4 info

[@Kadirtprk7]

there should be no change?

[@paul-stefanristea3369]

Nice! Thank you! Can't wait for a riding video :D:D:D

[@davidd6849]

Still happy with the mod ? I’m thinking of doing this mod this winter. Any check engine ?

[@arnoldelliott5695]

No check engine. Oem drivability. Great mod definitely 100% worth it! I recommend painting the pipe after with heat resistant paint. It looks better. I didnt do that, so ill have to go back and paint.

[@dano7480]

@@arnoldelliott5695 yes I painted my stock exhaust black and it's still holding up great.

[@vankomt]

Did you remove the catalytic converter?

[@arnoldelliott5695]

No

[@jurgoSTI]

I wonder what a cat delete would do without trimming the other stuff… and then i wonder about trimming the length of the outlet pipes to just before it goes inside that path

[@yayoi1]

The cat delete makes the tone deeper and louder on a Super Tenere, so I'm guessing it'd do the same for this exhaust.

[@jurgoSTI]

@@yayoi1 well, i sourced another gen3 exhaust and recently removed the cat only and welded back together. Awaiting nicer weather to install and get some before and afters

[@yayoi1]

@@jurgoSTI I'm looking forward to hearing the results. :)

[@markprizeman4436]

@@jurgoSTI Hi very interested in your results

[@jurgoSTI]

@@markprizeman4436 hopefully soon! Waiting on some decent weather for install and videos

[@SylerP_95]

That thing is sick

[@ABNRONE]

Is that a Puig Touring windscreen?

[@arnoldelliott5695]

I got it off of amazon. A clone blacked out version of the yamaha oem screen.

[@ABNRONE]

@@arnoldelliott5695 Thanks for the reply. I've been looking for one for my 23' MT09, but most fall just behind the HUD.

[@jefmoto]

What windscreen is that?

[@arnoldelliott5695]

Its the oem yamaha

[@tommobruh]

Sounds good! Any chance of a ride video?

[@arnoldelliott5695]

Ill definitely try and make one!

[@sabinsesumariyan3687]

Super

[@hakankaradag4819]

bravo

[@PDPIE1029]

Thank you for this. Does it sound like a quieter name brand full system or an eBay full system. I’d like your input and anyone else who’s done this. Thank you everyone who actually ventured out to try this!!

[@arnoldelliott5695]

Its a great middle ground. I love my new Mivv exhaust. But if money is tight, this mod is 100% worth it! Sounds good. Not cheap & tinny!

[@PDPIE1029]

@@arnoldelliott5695 thank you!!

[@NateSVT]

@@arnoldelliott5695 How loud is the MIVV exhaust in your opinion? Ive seen people say they wouldn't recommend riding it without ear plugs because its so loud.

[@arnoldelliott5695]

@@NateSVT I ride it with the db killer installed. Perfect sound level imo. But with it uninstalled it’s definitely too loud. Great sound either way and a quality pipe

[@hugosantos5589]

f**** i love it... and cat? you will remove? or stay whit cat ?

[@hugosantos5589]

Do you need ecu remap after this?